Nissan Rogue (T33) 2021-Present Service Manual: Main Line Between Avm and Sonar Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Lan System / Can :: Dtc/circuit Diagnosis / Main Line Between Avm and Sonar Circuit

Diagnosis Procedure

CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

  1. Turn the ignition switch OFF.

  2. Disconnect the battery cable from the negative terminal.

  3. Disconnect the following harness connectors.

    • Around view monitor control unit

    • Sonar control unit

    • ADAS control unit 2

  4. Check the continuity between the around view monitor control unit harness connector and the sonar control unit harness connector.

    Around view monitor control unit harness connector Sonar control unit harness connector Continuity
    Connector No. Terminal No. Connector No. Terminal No.
    B75 6 B20 5 Existed
    23 6 Existed

Is the inspection result normal?

YES (Present error)>>

Check CAN system type decision again.

YES (Past error)>>

Error was detected in the main line between the around view monitor control unit and the sonar control unit.

NO>>

Repair the main line between the around view monitor control unit and the sonar control unit harness connector.

    Main Line Between Dm Cam and Lane Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damag...
    Main Line Between Strg and Brake Circuit
    Diagnosis Procedure CHECK CONNECTOR Ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend a...

    Other materials:

    P1536 Ascd System
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1536 00 Cruise control (Cruise control) Diagnosis condition Ignition switch ON Signal CAN communication signal Threshold ECM cannot receive a ...

    Symptom Diagnosis. Heated Steering Wheel System Does Not Activate
    Description The heated steering wheel does not warm up. The heated steering wheel system cannot be turned OFF. Diagnosis Procedure PERFORM SELF DIAGNOSTIC RESULT CONSULT Ignition switch ON. Select “Self Diagnostic Result” mode of “HVAC”. Check DTC. Is DT ...

    P11a9 Vcr Target Angle
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P11A9 00 VCR target angle (Variable compression ratio target angle) Diagnosis condition Engine running at idle Signal (terminal) — Threshold ...