Nissan Rogue Service Manual: ID registration cannot be completed
Description
The ID of the tire pressure sensor installed in each wheel cannot be registered in the tire pressure monitoring system. Inspect the tire pressure sensor or the tire pressure monitoring system circuit.
Diagnosis Procedure
1.CHECK TIRE PRESSURE SENSOR ACTIVATION TOOL
Check tire pressure sensor activation tool.
Is the inspection result normal? YES >> GO TO 2.
NO >> Replace the battery of tire pressure sensor activation tool or repair/replace the tire pressure sensor activation tool.
2.TIRE PRESSURE SENSOR ID REGISTRATION
Perform tire pressure sensor ID registration. Refer to WT-21, "Work Procedure"
CAUTION: To perform ID registration, observe the following points:
- Never register ID in a place where radio waves are interfered (e.g. radio tower).
- Never register ID in a place close to vehicles including TPMS.
Is tire pressure sensor ID registration completed? YES >> Inspection End.
NO >> GO TO 3.
3.CHECK TIRE PRESSURE SIGNAL
Change the work location and perform ID registration again.
NOTE: Depending on the tire pressure sensor position*, a blind spot exists, and the tire pressure receiver gets poor reception. If an ID registration is performed under this condition, the registration may not be completed. In such case, follow the instructions below to improve the radio wave receiving environment.
- Rotate tire by 90°, 180°, or 270°. (This Step is to change tire pressure sensor position.)
- Open the door close to the tire of which ID registration is ongoing.
*: Radio wave reception condition depends on vehicle architecture (e.g. body harness layout, tire wheel design) or environment.
When ID registration is performed, which wheels do not react? All wheels react and ID registration is possible.>>Inspection End.
Only certain wheel(s) do not react.>>Replace applicable tire pressure sensor. Refer to WT-61, "Removal and Installation".
All wheels do not react.>>Replace BCM. Refer to BCS-75, "Removal and Installation" (with Intelligent Key System) or BCS-135, "Removal and Installation" (without Intelligent Key System).
Low tire pressure warning lamp blinks
Description
The low tire pressure warning lamp blinks when the power switch is turned ON.
NOTE:
The position of an inactive tire pressure sensor can be identified by checking
the blinking timing ...
Easy fill tire alert does not activate
Description
The easy fill tire alert does not function while inflating a tire when the
select lever position is in P-range with the
power switch ON or with the vehicle set to READY.
NOTE:
&nb ...
Other materials:
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
...
System
SRS AIR BAG SYSTEM
SRS AIR BAG SYSTEM : System Description
SYSTEM DIAGRAM
DESCRIPTION
The air bag deploys if the air bag diagnosis sensor unit is
activated while the ignition switch is in the ON or
START position.
The collision modes for which supplemental restraint sys ...
B0010, B0011 passenger airbag module
DTC Logic
DTC DETECTION LOGIC
CONSULT name
DTC
DTC detecting condition
Repair order
ASSIST AIRBAG MODULE CIRCUIT
[OPEN]
B0010
Front passenger air bag module circuit
(AS1) is open.
Refer to SRC-49, "Diagnosis Procedure".
ASS ...
