The Nissan Rogue is designed to be driven with the Vehicle Dynamic Control (VDC) system ON during normal conditions, as this improves stability and traction.
However, when the vehicle becomes stuck in deep snow or mud, the VDC system may limit engine output to reduce wheel spin. In these situations, even pressing the accelerator fully may not increase engine speed. If you need maximum power to free the Nissan Rogue, turning the VDC system off can help.

Example
To turn off the VDC system, follow these steps using the vehicle information display:
1. Press the
button on the steering wheel until “Settings” appears, then press the jog dial.
2. Use the scroll dial to choose “VDC Setting,” then press it.
3. Select “System” and press the scroll dial. The
indicator light will illuminate to show VDC is off.
To turn the VDC system back on, reactivate “VDC Setting” in the display or simply restart the Nissan Rogue’s engine.
Brake Force Distribution
While braking during cornering, the system distributes braking force to each individual wheel based on the turn radius, improving control and stability.
WARNING
Always reduce speed on slippery surfaces and drive cautiously.
light to flash or the
and
indicators to illuminate.
and
warning lights may illuminate.
and
indicators may illuminate.
light may flash or both the
and
indicators may illuminate. Avoid driving on such surfaces.
indicator may flash or both the
and
lights may illuminate. This is not a malfunction. Restart the engine on stable ground.
light to flash or both the
and
indicators to illuminate.
Basic information
Chassis controlWater pump
Exploded View
Cylinder block
Water pump
Water pump gasket
Water pump housing
O-ring
Water pipe
Water pump housing gasket
Refer to INSTALLATION
Removal and Installation
REMOVAL
Drain engine coolant. Refer to CO-8, "Draini ...
Symptom diagnosis
SQUEAK AND RATTLE TROUBLE DIAGNOSES
Work Flow
CUSTOMER INTERVIEW
Interview the customer if possible, to determine the conditions that exist
when the noise occurs. Use the Diagnostic
Worksheet during the interview to document the facts and conditions when the
noise occurs and any
custome ...
DTC/circuit diagnosis
POWER SUPPLY AND GROUND CIRCUIT
AUDIO UNIT
AUDIO UNIT : Diagnosis Procedure
Regarding Wiring Diagram information, refer to AV-27, "Wiring Diagram".
1.CHECK FUSE
Check that the following fuses are not blown.
Are the fuses blown?
YES >> Replace the blown fuse after repairing t ...