Nissan Rogue manuals

Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: How to enable/disable the RCTA system

Nissan Rogue. Rear Cross Traffic Alert (RCTA)

  1. Steering-wheel-mounted controls (left side)
  2. Vehicle information display

1. Push the button until "Settings" appears in the vehicle information display and then push the scroll dial.

Use the scroll dial to select "Driver Assistance". Then push the scroll dial.

2. Type A (if so equipped): Select "Parking Assist" and push the scroll dial. Then select "Rear Cross Traffic Alert" and push the scroll dial to turn the system ON or OFF.

Type B (if so equipped): Select "Rear Cross Traffic Alert" and push the scroll dial to turn the system ON or OFF.

NOTE:

The selected RCTA setting will be retained even if the Nissan Rogue engine is turned off and restarted.

RCTA system limitations

Nissan Rogue. Rear Cross Traffic Alert (RCTA)

WARNING

Listed below are the system limitations for the RCTA system. Failure to operate the Nissan Rogue in accordance with these limitations could result in serious injury or death.

Nissan Rogue. Rear Cross Traffic Alert (RCTA)
Illustration 1

Nissan Rogue. Rear Cross Traffic Alert (RCTA)
Illustration 2

NOTE:

When several vehicles approach in succession (Illustration 1) or when vehicles approach from opposite directions (Illustration 2), the RCTA system on the Nissan Rogue may not sound an additional chime after the first vehicle passes the sensors.

Basic information
WARNING Failure to follow the warnings and instructions for proper use of the RCTA system on your Nissan Rogue could result in serious injury or death. The RCTA system is not a replacement for safe ...

System temporarily unavailable
When radar blockage is detected on the Nissan Rogue, the system will deactivate automatically. The "Unavailable Side Radar Obstruction" warning message appears in the vehicle information display. The ...

Other materials:

Spiral cable
Exploded View Combination switch Steering angle sensor Spiral cabl Removal and Installation WARNING:  Before servicing the SRS, turn ignition switch OFF, disconnect both battery terminals then wait at least three minutes.  Do not use the air tools or electric t ...

Preparation
Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description — (J-39570) Chassis Ear Locating the noise — (J-50397) NISSAN Squeak and Rattle Kit ...

DTC/circuit diagnosis
P1610 LOCK MODE Description ECM forcibly switches to the mode that inhibits engine start, when engine start operation is performed 5 times or more while communication between ECM and BCM is not normal. DTC Logic DTC DETECTION LOGIC NOTE:  If DTC B1610 is displayed with DTC U1000, fi ...

© 2014-2025 Copyright www.nirogue.com