Nissan Rogue Service Manual: Front wiper motor ground circuit
Diagnosis Procedure
Regarding Wiring Diagram information, refer to WW-22, "Wiring Diagram".
1. CHECK FRONT WIPER MOTOR GROUND CIRCUIT
- Turn the ignition switch OFF.
- Disconnect front wiper motor.
- Check continuity between front wiper motor harness connector and ground.
Is the inspection result normal? YES >> Front wiper motor ground circuit is normal.
NO >> Repair or replace harness.
Front wiper auto stop signal circuit
Component Function Check
1. CHECK FRONT WIPER (AUTO STOP) SIGNAL
Select FR WIPER STOP of BCM (WIPER) data monitor item.
Operate the front wiper.
Check that FR WIPER STOP cha ...
Washer motor circuit
Diagnosis Procedure
Regarding Wiring Diagram information, refer to WW-22, "Wiring Diagram".
1. CHECK FRONT AND REAR WASHER MOTOR FUSE
Turn the ignition switch OFF.
Check ...
Other materials:
P0138 HO2S2
DTC Description
DTC DETECTION LOGIC
The heated oxygen sensor 2 has a much longer switching time between rich and
lean than the air fuel ratio (A/
F) sensor 1. The oxygen storage capacity of the three way catalyst (manifold)
causes the longer switching
time.
MALFUNCTION A
To judge the malfu ...
Removal and installation
HORN
Exploded View
Horn (LOW)
Horn (HIGH)
Removal and Installation
REMOVAL
Horn (LOW)
Remove the front grille. Refer to EXT-23, "Removal and
Installation".
Disconnect the harness connectors from the horn (LOW).
NOTE:
Before disconnecting the harn ...
P2118 throttle control motor
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P2118
ETC MOT-B1
(Throttle actuator control motor current
range/performance)
ECM detects short in both circuits between ECM and throttle control ...
