Nissan Rogue Service Manual: Front regulator

Nissan Rogue Service Manual / Body exterior, doors, roof & vehicle security / Glass & Window System / Removal and installation / Front regulator

Exploded View

Exploded View

Front door panel
Front door regulator
Front door power window motor
Front door glass run rear
Front door glass run front
Front door glass
Front door glass rubber run

Removal and Installation

REMOVAL

Remove the front door finisher. Refer to INT-15, "Removal and Installation".
Partially remove vapor barrier.

Removal

Temporarily reconnect the main power window and door lock/unlock switch (LH door) or power window door lock/unlock switch RH (RH door).
Operate the power window and door lock/unlock switch (LH door) or front door power window motor and door lock/unlock switch RH (RH door) to raise/lower the front door glass until the front door regulator to front door glass bolts can be seen.
Raise the front door glass and hold in place using a suitable tool (A).

Removal

Disconnect the harness connector from the front power window motor.
Remove the bolts (A) and remove the front door glass regulator.

Removal

INSPECTION AFTER REMOVAL

Check the front door glass regulator for the following items:

Wire wear
Front door glass regulator deformation
Grease condition for each sliding part

If a malfunction is detected, replace or grease it.

The arrows in the figure show the application points of the suitable multi-purpose grease, if needed.

Inspection after removal

Inspection and Adjustment

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

When the main power window and door lock/unlock switch or front power window and door lock/ unlock switch RH is removed it is necessary to perform the initialization procedure. Refer to PWC- 27, "ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL : Special Repair Requirement".
Tighten front door regulator bolts to specification. Refer to GW-16, "Exploded View".

FITTING INSPECTION

Check that the front door glass is fit securely into the glass run groove.
Lower the front door glass slightly [approximately 10 to 20 mm (0.39 to 0.79) and check that the clearance to the run is parallel.If the clearance between the glass and sash is not parallel, loosen the front door glass regulator bolts, front door glass run channel bolts, and glass and run rail bolts to correct the glass position.

Front door glass

Exploded View Front door Front regulator Front power window motor Front door glass rear run Front door glass front run Front door glass Front door glass rubber run Remo ...

Front power window motor

Removal and Installation REMOVAL Remove front door glass regulator. Refer to GW-16, "Removal and Installation". Remove screws (A) and front power window motor (1) from ...

Other materials:

U1010 control unit (CAN)
Description Air bag diagnosis sensor performs self-tests on key ON. If CAN communication failure within control unit is detected, DTC is set. DTC Logic DTC DETECTION LOGIC CONSULT name DTC DTC detecting condition Repair order CAN CONTROL UNIT FAILURE ...

VDC off switch
Removal and Installation REMOVAL Remove the instrument lower panel LH. Refer to IP-14, "INSTRUMENT PANEL ASSEMBLY : Removal and Installation". Release pawls using suitable tool and remove the VDC OFF switch (2) from the upper switch carrier (1). : Pawl INST ...

Throttle valve closed position learning
Description Throttle Valve Closed Position Learning is a function of ECM to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be performed each time the harness connector of the electric throttle control actuator or ECM is ...