Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Exterior rear
- Rear window defroster — helps clear frost and fog from the Nissan Rogue’s rear window for better visibility.
- Rear window wiper and washer
- Switch operation — controls for activating the rear wiper system.
- Window washer fluid — spray system used to clean the rear glass.
- High-mounted stop light — elevated brake light that improves visibility to drivers behind.
- Antenna** — roof-mounted antenna used for radio and navigation functions in the Nissan Rogue.
- Roof rack* — available roof-mounted rails for carrying cargo or accessories.*
- Sonar sensors (center and corner)
- Sonar system* — assists with obstacle detection when parking.*
- Rear Sonar System (RSS)* — alerts the driver to objects behind the vehicle.*
- Rear Automatic Braking (RAB) — system that can automatically apply brakes to help avoid collisions.
- ProPILOT Assist 2.1* — advanced driver-assist technology available on certain Nissan Rogue models.*
- Liftgate
- Intelligent Key system* — allows hands-free or remote liftgate access.*
- Rear view camera* — provides a rearward image to assist with reversing.*
- Rear combination light — includes brake lights, tail lights, and turn signals.
- Sonar sensors (side)*
- Rear Automatic Braking (RAB) — additional assistance to avoid rear obstacles.
- Sonar system — helps detect objects around the rear sides.
- ProPILOT Assist 2.1* — integrates side sensors for enhanced driver assistance.*
- Fuel-filler door
- Fuel information — details regarding the recommended fuel type for the Nissan Rogue.
- Child safety rear door locks — locks designed to prevent rear doors from being opened from the inside.
*: if so equipped
**: For ProPILOT Assist 2.1 models, the Nissan Rogue uses two roof antennas (left: GNSS antenna, right: radio antenna).
For ProPILOT Assist and ProPILOT Assist 1.1 models, there is one antenna.
Other materials:
Stop Lamp Circuit
Component Function Check
CHECK STOP LAMP OPERATION
Ignition switch ON.
With operating the brake pedal, check that the stop lamp and high-mounted stop lamp is turned ON.
Depressed
: Stop lamp and high-mounted stop lamp ON
Fully released
: Stop lamp and high-mounted stop lamp O ...
B24a1-16 A/c Auto Amp. Power Supply
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
B24A1-16
A/C AUTO AMP. POWER SUPPLY
(Air conditioning automatic amplifier power supply)
Diagnosis condition
Ignition switch ON
Signal (Terminal)
Accessory p ...
Writing of Calibration Data
Work Procedure
DESCRIPTIONIf only the around view monitor control unit
is replaced, the calibration data stored in the camera can be written
to the around view monitor control unit by selecting "Camera
Calibration" of "Work Support" mode in CONSULT.WORK PROCEDUREWRITE CALIBRATION DATA
With C ...
