Nissan Rogue Service Manual: Exterior Lighting System

Door mirror remote control switch

Removal and Installation REMOVAL  Release pawls using a suitable tool and remove front door pull handle (LH). Refer to INT-15, "Exploded View".  Release pawls (B) using ...

Halogen headlamp

...

Other materials:

NISSAN Jackknife key (if so equipped)
Replace the battery in the jackknife key as follows: Hold jackknife key button side up. Insert a small screwdriver into the slit of the corner and twist it to separate the upper part from the lower part. Use a cloth to protect the casing.  Remove old battery.  Replace t ...

Luggage room lamp
Removal and Installation REMOVAL Insert a suitable tool (A) into the gap between the luggage lower finisher (RH) (2) and the top of luggage room lamp (1) to release the pawl. : Pawl Disconnect the harness connector from the luggage room lamp and remove. INSTALLATION Installati ...

DTC/circuit diagnosis
U1000 CAN COMM CIRCUIT Description Refer to LAN-8, "System Description". DTC Logic DTC DETECTION LOGIC NOTE: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual CAN diagnostic symptoms and a present DTC by p ...