Nissan Rogue Service Manual: Door mirror remote control switch
Removal and Installation
REMOVAL
- Release pawls using a suitable tool and remove front door pull handle (LH). Refer to INT-15, "Exploded View".
- Release pawls (B) using a suitable tool and remove door mirror remote control switch (1).
- Remove screws (A) and door mirror remote control switch bracket (2) (if necessary).
INSTALLATION
Installation is in the reverse order of removal.
Side camera finisher
Removal and Installation
The side camera finisher (if equipped) or door mirror lower finisher is
serviced as part of the door mirror rear
finisher. Refer to MIR-25, "Removal and Installation& ...
Other materials:
Blower motor
Exploded View
Heating and cooling unit assembly
Blower motor
Screw
Front
Removal and Installation
REMOVAL
Remove glove box assembly. Refer to IP-23, "Removal and Installation".
Disconnect the harness connector from the blower motor.
Remove ...
P0713 transmission fluid temperature sensor A
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0713
FLUID TEMP SENSOR A
(Transmission Fluid Temperature Sensor A Circuit
High)
When all of the following conditions are satisfied and this state i ...
P0643 sensor power supply
Description
ECM supplies a voltage of 5 V to some of the sensors systematically divided
into 2 groups, respectively.
Accordingly, when a short circuit develops in a sensor power source, a
malfunction may occur simultaneously
in the sensors belonging to the same group as the short-circuited ...
