Nissan Rogue Service Manual: EPS warning lamp
Component Function Check
1.CHECK THE ILLUMINATION OF THE EPS WARNING LAMP
Check that the EPS warning lamp turns ON when ignition switch turns ON. Then, EPS warning lamp turns OFF after the engine is started.
Is the inspection result normal? YES >> Inspection End.
NO >> Perform trouble diagnosis. Refer to STC-28, "Diagnosis Procedure".
Diagnosis Procedure
1.PERFORM SELF-DIAGNOSIS
With CONSULT
- Turn the ignition switch OFF to ON.
- Perform “EPS” self-diagnosis.
Is any DTC detected? YES >> Check the DTC. Refer to STC-13, "DTC Index".
NO >> GO TO 2.
2.CHECK EPS WARNING LAMP SIGNAL
With CONSULT
- Turn the ignition switch ON.
CAUTION: Never start the engine.
- Select “DATA MONITOR” of “EPS” and select “WARNING LAMP”.
- Check that the EPS warning lamp is turned ON.
- Start the engine.
CAUTION: Never drive the vehicle.
- Check that the EPS warning lamp is turned OFF.
Is the inspection result normal? YES >> Perform the trouble diagnosis for combination meter power supply circuit. Refer to WCS-39, "COMBINATION METER : Diagnosis Procedure".
NO >> EPS control unit is malfunctioning. Replace steering column assembly. Refer to STC-36, "Removal and Installation".
U1000 CAN COMM circuit
Description
CAN (Controller Area Network) is a serial communication line for real time
application. It is an on-vehicle multiplex
communication line with high data communication speed and excellen ...
Other materials:
P0744 torque converter
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0744
TORQUE CONVERTER
(Torque converter clutch circuit intermittent)
When all of the following conditions are satisfied and this state is
maintain ...
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
...
Auto operation does not operate
MOONROOF
MOONROOF : Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to RF-24, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair
Requirement".
Is the inspection result normal?
YES >> Moonroof system is normal.
...
