Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: U0075-00 Control Module Comm Bus C Off
DTC Description
DESCRIPTION
CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern Nissan Ariya vehicle is equipped with many electronic control unit, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN-High line, CAN-Low line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only. CAN Communication Signal Chart. Refer to CAN Communication Signal Chart.
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| U0075-00 |
Control module comm Bus C Off (Control module communication bus C Off) |
Diagnosis condition | Ignition switch is ON. |
| Signal (terminal) | CAN communication signal | ||
| Threshold | BCM cannot communicate CAN communication signal. | ||
| Diagnosis delay time | 2 seconds or more. | ||
POSSIBLE CAUSE
CAN communication system
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
CHECK SELF-DIAG RESULT
CONSULT
-
Ignition switch ON and wait for 2 seconds or more.
-
Select “Self diagnosis result” mode of “BCM”.
Is DTC detected?
YES>>Refer to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End.
DTC Diagnosis Procedure
CHECK CAN COMMUNICATION SYSTEM
Check CAN communication system. Refer to Trouble Diagnosis Flow Chart.
>>
Inspection End.
Other materials:
Dtc/circuit Diagnosis. B2c95-64 Combination Switch
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC Detection Condition
B2C95-64
Combination switch
(Combination switch)
Diagnosis condition
Ignition switch OFF (auto ACC status)
Signal (terminal)
Combination switch signal
...
Power Supply and Ground Circuit
Side Radar Front Lh
Diagnosis Procedure
CHECK FUSE
Check that the following fuse is not blown:
Signal name Fuse No.
Ignition power supply
9 (10 A)
Is the fuse blown?
YES>>
Replace the blown fuse after repairing the affected circuit.
NO>>
GO TO 2.
CHECK POWER SU ...
Ecu Diagnosis Information. Hands Free Sensor Control Unit
Reference Value
TERMINAL LAYOUTPHYSICAL VALUES
Terminal No.
(Wire color) Description Condition
Voltage
(Approx.)
(+) (–) Signal name Input/Output
1
(GR)
Ground
Serial communication
Input/Output
Ignition switch ON
2
(L)
Ground
Power supply (BAT)
...
