Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: C1734-68 Tire Pressure Sensor Rl
DTC Description
NOTE:
The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.
-
Activate and display TPMS sensor IDs
-
Display tire pressure reported by the TPMS sensor
-
Read TPMS DTCs
-
Register TPMS sensor IDs
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | ||||
|---|---|---|---|---|---|---|
| C1734-68 |
Tire pressure sensor RL (Tire pressure sensor rear left) |
1 | Diagnosis condition |
Drive the Nissan Ariya vehicle at 25 MPH (40 km/h) or more.
When DTC is memorized, DTC is displayed again at ignition switch ON. |
||
| Signal (terminal) | Temperature data signal. | |||||
| Threshold | Malfunction in the tire pressure data from the rear left tire pressure sensor. | |||||
| Diagnosis delay time | 1 second or less. | |||||
| 2 | Diagnosis condition |
Drive the Nissan Ariya vehicle at 25 MPH (40 km/h) or more.
When DTC is memorized, DTC is displayed again at ignition switch ON. |
||||
| Signal (terminal) | Temperature data signal. | |||||
| Threshold | Malfunction in the tire temperature data from the rear left tire pressure sensor. | |||||
| Diagnosis delay time | 1 second or less. | |||||
| 3 | Diagnosis condition |
Drive the Nissan Ariya vehicle at 25 MPH (40 km/h) or more.
When DTC is memorized, DTC is displayed again at ignition switch ON. |
||||
| Signal (terminal) | Temperature data signal. | |||||
| Threshold | Malfunction in the G sensor data from rear left tire pressure sensor. | |||||
| Diagnosis delay time | 1 second or less. | |||||
POSSIBLE CAUSE
Rear left tire pressure sensor
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
PERFORM SELF DIAGNOSIS RESULT
CONSULT
Perform “Self diagnosis result” mode of “BCM”.
Is DTC “C1734-68” detected?
YES>>Refer to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End.
DTC Diagnosis Procedure
NOTE:
The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.
-
Activate and display TPMS sensor IDs
-
Display tire pressure reported by the TPMS sensor
-
Read TPMS DTCs
-
Register TPMS sensor IDs
PERFORM SELF DIAGNOSIS RESULT
Replace rear left tire pressure sensor even if other DTCs are displayed along with “C1734-68” in “Self diagnosis result” mode of “BCM”.
>>
Replace rear left tire pressure sensor. Refer to Removal & Installation.
Other materials:
C0513 Wheel Speed Sensor
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
C0513
00
Right rear wheel speed sensor
(Right Rear Wheel Speed Sensor Range/Performance)
Diagnosis condition
Ignition switch ON
Battery voltage: 11 V ...
Symptom Diagnosis. Intelligent Key Low Battery Warning Does Not Operate
Diagnosis Procedure
CHECK INFORMATION DISPLAY
Check information display.
Refer to Work flow.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair or replace the malfunctioning parts.
CHECK INTELLIGENT KEY BATTERY
Check Intelligent Key battery.
Refer to Component Inspe ...
Brake fluid
For more information on brake fluid type and capacity, refer to “Capacities and recommended fluids/lubricants”.
WARNING
Always use new brake fluid from a sealed container. Contaminated, old, or poor-quality fluid may damage the brake system and reduce stopping performance.
Clean the filler c ...
