Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B2437-98 Spindle Motor Rh
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| B2437-98 |
Spindle motor RH (Spindle motor right hand) |
Diagnosis condition | All times |
| Signal (terminal) | — | ||
| Threshold | When thermal protection operate of the spindle motor RH | ||
| Diagnosis delay time | 45 seconds or more | ||
POSSIBLE CAUSE
Automatic back door control unit
FAIL-SAFE
Inhibit automatic back door system (only operate back door closure function)
DTC CONFIRMATION PROCEDURE
DTC CONFIRMATION
CONSULT
-
Ignition switch ON and wait for 45 seconds or more.
-
Select “Self diagnosis result” mode of “AUTOMATIC BACK DOOR”.
Is DTC detected?
YES>>Refer to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End.
DTC Diagnosis Procedure
CHECK SELF DIAGNOSIS RESULT
CONSULT
-
Wait for 75 seconds or more.
-
Ignition switch ON.
-
Select “Self diagnosis result” mode of “AUTOMATIC BACK DOOR”.
What is the display history of DTC “B2437-98”?
“CRNT”>>Replace automatic back door control unit. Refer to Removal and Installation.
“PAST”>>Inspection End.
Other materials:
Dtc/circuit Diagnosis. B0028-1a Side A/b Module Rh
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC Detection Condition
B0028-1A
SIDE A/B MODULE RH
(Right Side Airbag Deployment Control)
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
Front side air bag modu ...
C10b1-01 Parking Brake Actuator (lh)
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C10B1
01
Parking brake actuator (LH)
[Parking brake actuator (left)]
Diagnosis condition
When parking brake is apply or release
Signal (terminal)
—
...
Dtc/circuit Diagnosis. C1731-16 Tire Pressure Sensor Fl
DTC Description
NOTE:
The Signal Tech II Tool [– (NI-50190)] can be used to
perform the following functions: Refer to the Signal Tech II User Guide
for additional information.
Activate and display TPMS sensor IDs
Display tire pressure reported by the TPMS sensor
Read TPMS DTCs ...
