Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B0091-55 Door Satel Sens Lh
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| B0091–55 |
DOOR SATEL SENS LH (Left Side Restraints Sensor 1) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | Front door satellite sensor LH signal | ||
| Threshold | When a mismatch is detected between in the configuration data stored in the air bag diagnosis sensor unit and Nissan Ariya vehicle specification. | ||
| Diagnosis delay time | 2 seconds or more. | ||
POSSIBLE CAUSE
-
Connection malfunction of harness and connector
-
Mistake of configuration for air bag diagnosis sensor unit
-
Internal malfunction of air bag diagnosis sensor unit
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
CHECK SELF DIAGNOSIS RESULT
CONSULT
-
Ignition switch ON.
-
Perform “Self diagnosis result” mode of “AIR BAG” using CONSULT.
Is malfunctioning part detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End
Diagnosis Procedure
WARNING:
-
Before servicing, ignition switch OFF, disconnect battery negative terminal, and wait at least 3 minutes or more. (To discharge backup capacitor.)
-
Never use unspecified tester or other measuring device.
CHECK HARNESS CONNECTOR
Check the harness connector.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Replace harness connector.
CHECK WIRING HARNESS
Check the wiring harness externals.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Replace wiring harness.
PERFORM CONFIGURATION
-
Perform configuration for air bag diagnosis sensor unit. Refer to Description.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>GO TO 4.
NO>>Inspection End
REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
-
Replace air bag diagnosis sensor unit. Refer to Removal and Installation.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>GO TO 1.
NO>>Inspection End
Other materials:
Power Socket. Removal and Installation. Power Socket
Power Socket
Console Power Socket
Removal and Installation
REMOVALRemove switch panel. Refer to Removal and Installation.
Press the power socket fixing pawls from the back of the switch panel to remove the power socket.
: Pawl
INSTALLATIONNote the following, and install in the reve ...
C0513 Wheel Speed Sensor
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
C0513
00
Right rear wheel speed sensor
(Right Rear Wheel Speed Sensor Range/Performance)
Diagnosis condition
Ignition switch ON
Battery voltage: 11 V ...
Tcm
Reference Value
CONSULT DATA MONITOR STANDARD VALUE
In CONSULT, electric shift timing or lock-up timing, i.e. operation
timing of each solenoid valve, is displayed. Therefore, if there is an
obvious difference between the shift timing estimated from a shift shock
(or engine speed variation ...
