Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B0030-1a Rear Side A/b Module Lh
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| B0030-1A |
REAR SIDE A/B MODULE LH (Second Row Left Side Airbag Deployment Control) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | Rear side air bag module LH signal | ||
| Threshold | Rear side air bag module LH circuits are shorted to each other | ||
| Diagnosis delay time | 2 seconds or more. | ||
POSSIBLE CAUSE
-
Connection malfunction or short circuit of harness and connector
-
Internal malfunction of rear side air bag module LH
-
Internal malfunction of air bag diagnosis sensor unit
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
CHECK SELF DIAGNOSIS RESULT
CONSULT
-
Ignition switch ON.
-
Perform “Self diagnosis result” mode of “AIR BAG” using CONSULT.
Is malfunctioning part detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End
Diagnosis Procedure
WARNING:
-
Before servicing, ignition switch OFF, disconnect battery negative terminal, and wait at least 3 minutes or more. (To discharge backup capacitor.)
-
Never use unspecified tester or other measuring device.
CHECK HARNESS CONNECTOR
Check the harness connector.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Replace harness connector.
CHECK WIRING HARNESS
Check the wiring harness externals.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Replace wiring harness.
REPLACE REAR SIDE AIR BAG MODULE LH
-
Replace rear side air bag module LH. Refer to Removal and Installation.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>GO TO 4.
NO>>Inspection End
REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
-
Replace air bag diagnosis sensor unit. Refer to Removal and Installation.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>GO TO 1.
NO>>Inspection End
Other materials:
B2231-16 Battery Voltage
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detected condition
B2231-16
Battery voltage
(Battery voltage)
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
Battery power supply
Threshold
8 V or le ...
P02ee Fuel Injector
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P02EE
00
Cylinder 1 injector
(Cylinder 1 Injector Circuit Range/Performance)
Diagnosis condition
Injector compensation control is operating
Signal
— ...
Lane Branch Line Circuit
Diagnosis Procedure
CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the front camera unitfor damage, bend and loose connection (unit side and connector side).
Is the inspection result no ...
