Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B0002-1a Driver Airbag Module 2
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| B0002-1A |
DRIVER AIRBAG MODULE 2 (Driver Frontal Stage 2 Deployment Control) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | Driver air bag module signal | ||
| Threshold |
Driver air bag module circuits are shorted to each other (including the spiral cable) |
||
| Diagnosis delay time | 2 seconds or more. | ||
POSSIBLE CAUSE
-
Connection malfunction or short circuit of harness and connector
-
Internal malfunction of driver air bag module
-
Internal malfunction of air bag diagnosis sensor unit
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
CHECK SELF-DIAGNOSIS RESULT
CONSULT
-
Ignition switch ON.
-
Perform “Self diagnosis result” mode of “AIR BAG” using CONSULT.
Is malfunctioning part detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End
Diagnosis Procedure
WARNING:
-
Before servicing, ignition switch OFF, disconnect battery negative terminal, and wait at least 3 minutes or more. (To discharge backup capacitor.)
-
Never use unspecified tester or other measuring device.
CHECK HARNESS CONNECTOR
Check the harness connector.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Replace harness connector.
CHECK WIRING HARNESS
Check the wiring harness externals.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Replace wiring harness.
CHECK SPIRAL CABLE CIRCUIT
-
Ignition switch OFF.
-
Disconnect driver air bag module connector and spiral cable connector.
-
Check continuity between spiral cable terminals.
Terminal Continuity 39 40 Not existed
Is the inspection result normal?
YES>>GO TO 4.
NO>>Replace spiral cable. Refer to Removal and Installation.
REPLACE DRIVER AIR BAG MODULE
-
Replace driver air bag module. Refer to Removal and Installation.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>GO TO 5.
NO>>Inspection End
REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
-
Replace air bag diagnosis sensor unit. Refer to Removal and Installation.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>GO TO 1.
NO>>Inspection End
Other materials:
U2454-87 Can Comm Circuit
Without Propilot Assist 2.1
DTC Description
CAN COMMUNICATIONCAN (Controller Area Network) is a
serial communication line for real time applications. It is an on-Nissan
Ariya vehicle multiplex communication line with high data communication
speed and excellent error detection ability. Mode ...
Dtc/circuit Diagnosis. C1731-16 Tire Pressure Sensor Fl
DTC Description
NOTE:
The Signal Tech II Tool [– (NI-50190)] can be used to
perform the following functions: Refer to the Signal Tech II User Guide
for additional information.
Activate and display TPMS sensor IDs
Display tire pressure reported by the TPMS sensor
Read TPMS DTCs ...
Dtc/circuit Diagnosis. B0028-09 Side A/b Module Rh
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC Detection Condition
B0028-09
SIDE A/B MODULE RH
(Right Side Airbag Deployment Control)
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
Front side air bag modu ...
