Nissan Rogue (T33) 2021-Present Service Manual: C1bb4-46 Control Module

Nissan Rogue (T33) 2021-Present Service Manual / Cruise Control & Driver Assistance :: Driver Assistance System / Chassis Control :: Dtc/circuit Diagnosis / C1bb4-46 Control Module

DTC Description

DTC DETECTION LOGIC

DTC No. CONSULT screen terms DTC detection condition
C1BB4 46 Control module Diagnosis condition When ignition switch is ON.
Signal (terminal) -
Threshold Chassis control module is malfunctioning.
Diagnosis delay time 1 second or less

POSSIBLE CAUSE

Chassis control module

FAIL-SAFE

The following functions are suspended.*

  • Intelligent trace control function

  • Active ride control function

  • Automatic brake hold function

  • Drive mode selector function

*: Depends on the DTC detection status

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 10 seconds before conducting the next test.

>>

GO TO 2.

CHECK DTC DETECTION

With CONSULT

  1. Ignition switch OFF to ON.

    CAUTION:

    Be sure to wait of 10 seconds after ignition switch OFF or ON.

  2. Perform self-diagnosis for “CHASSIS CONTROL”.

Is DTC “C1BB4-46” detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

PERFORM SELF-DIAGNOSIS

With CONSULT

  1. Erase self-diagnosis result for “CHASSIS CONTROL”.

  2. Ignition switch OFF and wait for 10 seconds or more.

  3. Ignition switch ON.

  4. Perform self-diagnosis for “CHASSIS CONTROL”.

Is DTC “C1BB4-46” detected?

YES>>

Replace the chassis control module. Refer to Removal and Installation.

NO>>

INSPECTION END

    C1bb4-45 Control Module
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition C1BB4 45 Control module Diagnosis condition When ignition switch is ON. Signal (terminal...
    C1bb4-49 Control Module
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition C1BB4 49 Control module Diagnosis condition When ignition switch is ON. Signal (terminal...

    Other materials:

    Dtc/circuit Diagnosis. U2141-87 Can Comm Circuit
    DTC Description DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern Nissan Ariya vehicle is equipped ...

    Power Supply and Ground Circuit
    Ecm Diagnosis Procedure CHECK THE BATTERY CABLE Turn ignition switch OFF. Check the battery cable for tightening enough. NOTE: Check the continuity between the battery cable and the battery terminal. Is the inspection result normal? YES>> GO TO 2 ...

    Symptom Diagnosis. Easy Fill Tire Alert Does Not Activate
    Description The easy fill tire alert does not function while inflating a tire when the CVT shift selector position is in P-range with the ignition switch ON or with the engine started.NOTE: After starting to inflate the tire, it takes a few seconds for the easy fill tire alert to function. ...