Nissan Rogue Service Manual: C1769 configuration setting
DTC Description
This procedure must be performed:
- After replacement of BCM.
DTC DETECTION LOGIC
| DTC | Display Item | Malfunction detected condition |
| C1769 | CONFIG SETTING (Configuration setting) | Tire air pressure monitoring system configuration cannot be performed. |
| Receiver ID registration cannot be performed. |
Diagnosis Procedure
1.TIRE PRESSURE MONITORING SYSTEM CONFIGURATION
Perform configuration.
>> Refer to WT-21, "Work Procedure", and GO TO 2.
2.TIRE PRESSURE SENSOR ID REGISTRATION
Perform tire pressure sensor ID registration. Refer to WT-21, "Work Procedure".
Does low tire pressure warning lamp turn OFF? YES >> Inspection End.
NO >> Configuration setting tire pressure monitoring system. Refer to WT-21, "Work Procedure".
C1765, C1766, C1767, C1768 tire pressure sensor
DTC Description
DTC DETECTION LOGIC
DTC
Display Item
Malfunction Detected Condition
Possible Cause
C1765
WHEEL TOP DATA FL
(Wheel top data front left)
Malfunction i ...
C1770, C1771, C1772, C1773 G sensor
DTC Description
DTC DETECTION LOGIC
DTC
Display Item
Malfunction Detected Condition
Possible Causes
C1770
G SENSOR FL
(G sensor front left)
Malfunction in the G sen ...
Other materials:
1564 ASCD steering switch
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P1564
ASCD SW
(ASCD switch)
An excessively high voltage signal from the ASCD steering switch
is sent
to ECM.
ECM detect ...
DTC/circuit diagnosis
U0121 VDC CAN 2
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC U0121 is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to DAS-
106, "DISTANCE SENSOR : DTC Logic".
CONSULT Display
DTC Detection Condition
Possible Cause
...
P2096, P2097 A/F sensor 1
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P2096
POST CATALYST FUEL TRIM SYS B1
(Post catalyst fuel trim system too lean bank
1)
The output voltage computed by ECM from the A/F sensor 1 s ...
