Nissan Rogue Service Manual: C1765, C1766, C1767, C1768 tire pressure sensor
DTC Description
DTC DETECTION LOGIC
| DTC | Display Item | Malfunction Detected Condition | Possible Cause |
| C1765 | WHEEL TOP DATA FL (Wheel top data front left) | Malfunction in the wheel top data from the front LH wheel speed sensor. | Wheel speed sensor |
| C1766 | WHEEL TOP DATA FR (Wheel top data front right) | Malfunction in the wheel top data from the front RH wheel speed sensor. | |
| C1767 | WHEEL TOP DATA RR (Wheel top data rear right) | Malfunction in the wheel top data from the rear RH wheel speed sensor. | |
| C1768 | WHEEL TOP DATA RL (Wheel top data rear left) | Malfunction in the wheel top data from the rear LH wheel speed sensor. |
Diagnosis Procedure
1.PERFORM ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF-DIAGNOSIS
When DTC "C1765, C1766, C1767, C1768" is detected, perform ABS system diagnosis.
>> Perform ABS system diagnosis. Refer to BRC-55, "DTC Index".
C1735 ignition signal
DTC Logic
NOTE:
The Signal Tech II Tool [- (J-50190)] can be used to perform the following
functions. Refer to the Signal Tech II
User Guide for additional information.
Activate and dis ...
C1769 configuration setting
DTC Description
This procedure must be performed:
After replacement of BCM.
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
C1769
CONFIG SET ...
Other materials:
Power liftgate main switch
Power liftgate main switch
The power liftgate operation can be turned on or
off by the power liftgate main switch on the
instrument panel.
When the power liftgate main switch is pushed to
the OFF position, the power operation is not
available by the power liftgate switch on the
liftgate ...
P0111 IAT sensor
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P0111
IAT SENSOR 1 B1
(Intake air temperature sensor 1 circuit
range/performance bank 1)
The comparison result of signals transmitted to ECM fro ...
CAN system (type 6)
MAIN LINE BETWEEN IPDM-E AND DLC CIRCUIT
Diagnosis Procedure
1.CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and
loose connection (connector side
an ...
