Nissan Rogue (T33) 2021-Present Service Manual: C105c-92 Control Unit
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |||
|---|---|---|---|---|---|
| C105C | 92 |
Control unit (Control unit) |
Diagnosis condition |
|
|
| Signal (terminal) | — | ||||
| Threshold | Electric parking brake function malfunction | ||||
| Diagnosis delay time | 2 seconds or less | ||||
POSSIBLE CAUSE
NOTE:
Confirm if DTC is PAST or CRNT. If DTC is CRNT, proceed with Diagnosis Procedure. If DTC is PAST, clear DTC. Do not replace the ABS actuator and electric unit (control unit) for a PAST DTC.
| PAST DTC | CRNT DTC |
|---|---|
|
|
FAIL-SAFE
The following functions are suspended.
Electric parking brake function
DTC CONFIRMATION PROCEDURE
PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF (Auto ACC function OFF) before conducting the next test.
>>
GO TO 2.
CHECK DTC DETECTION
CONSULT
-
Ignition switch OFF (Auto ACC function OFF).
-
Start the engine.
NOTE:
Wait at least 10 seconds after start the engine.
-
Perform self-diagnosis for “ABS”.
Is DTC “C105C-92” detected?
YES-1>>“CRNT” is displayed: Refer to Diagnosis Procedure.
YES-2>>“PAST” is displayed: Inspection End (Erase the memory of self-diagnosis results.)
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End
Diagnosis Procedure
ADJUST THE NEUTRAL POSITION OF STEERING ANGLE SENSOR
-
Perform neutral position adjustment of steering angle sensor. Refer to Work Procedure.
-
Perform “All DTC Reading”.
Is DTC detected?
YES>>Check the DTC.
NO>>GO TO 2.
CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY AND GROUND CIRCUIT
Check the ABS actuator and electric unit (control unit) power supply and ground circuit. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair / replace harness, connector, terminal, fuse, or fusible link.
PERFORM SELF-DIAGNOSIS
CONSULT
Perform self-diagnosis for “ABS”.
NOTE:
Replace the ABS actuator and electric unit (control unit) even if other DTCs are displayed along with “C105C-92” in self-diagnosis for “ABS”.
Is DTC “C105C-92” detected?
YES>>Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation.
NO>>Inspection End [Although motor built in the ABS actuator and electric unit (control unit) operates temporarily without a break, this is not a malfunction. Erase the all memory of self-diagnosis results.]
Other materials:
Difference between predictive and actual distances
Basic information
The displayed guide lines and their positions on the ground are intended only as approximate references. When driving the Nissan Rogue on uphill, downhill, or uneven surfaces, or when objects extend outward, the actual distance may differ from what appears on the monitor relative t ...
U216e-87 Can Comm Circuit
DTC Description
CAN (Controller Area Network) is a serial communication system for
real time application. It is an on-Nissan Ariya vehicle multiplex
communication system with high data communication speed and excellent
error detectability. Many electronic control units are equipped onto
Nis ...
Dtc/circuit Diagnosis. B0028-09 Side A/b Module Rh
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC Detection Condition
B0028-09
SIDE A/B MODULE RH
(Right Side Airbag Deployment Control)
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
Front side air bag modu ...