Nissan Rogue (T33) 2021-Present Service Manual: Basic Inspection :: Mac Key Writing

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Body Control System / Basic Inspection :: Mac Key Writing

Description

When replacing BCM, it is necessary to write MAC key to BCM. Write MAC key to BCM according to "MAC Key writing" procedure of "CONSULT Operation Manual". Refer to Work Procedure.

CAUTION:

During MAC key writing, maintain the following conditions:

  • Ignition switch ON

  • CONSULT is connected to internet

Work Procedure

PERFORM MAC KEY WRITING

  1. Ignition switch ON.

  2. Select "MAC KEY writing" in "Work supports" mode of "BCM".

  3. Touch "Write".

YES>>

Work End.

    Basic Inspection. Shipping Mode Cancel Operation
    Work Procedure SHIPPING MODE CANCEL OPERATION Ignition switch OFF. Push in (switch on) the extended storage fuse switch. Refer to How To Check. Ignition switch ON. Ignition swit...
    Dtc/circuit Diagnosis. B2c95-01 Combination Switch
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B2C95-01 Combination switch (Combination switch) Diagnosis c...

    Other materials:

    B2e01-96 Tcu
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B2E01-96 Internal battery (Internal battery) Diagnosis condition When ignition switch is ON Signal (terminal) Internal battery Threshold Internal ba ...

    Dtc/circuit Diagnosis. U225b-87 Can Comm Err (ipdm E/r)
    DTC Description DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern Nissan Ariya vehicle is equipped ...

    Sheet Metal Work
    Sheet Metal Work Tools Sheet Metal Work Tools This section explains various tools used in body repair work. Hammers A hammer is used to correct dents, projections or other deformations. Various shapes have been designed according to their purposes.(1) TYPES AND FEATURES OF HAMMERS(2) SELECTI ...