Nissan Rogue (T33) 2021-Present Service Manual: Basic Inspection :: Configuration (bcm)
Description
Vehicle specification needs to be written with CONSULT because it is not written after replacing the BCM.
The configuration requires network connection. CONSULT connects to network and then it downloads the configuration data from the server. Then CONSULT writes the Nissan Ariya vehicle specification to the BCM.
Refer to Work Procedure.
NOTE:
For details the network connection and operation, refer to “CONSULT Operation Manual”.
The configuration no need to “save” configuration data from the BCM. The configuration data is always generated freshly at the server and then downloaded to the CONSULT.
CAUTION:
-
Complete the procedure of “Configuration” in order.
-
If incorrect “Configuration”, incidents might occur.
-
Never perform “Configuration” except for new BCM.
Work Procedure
WRITING VEHICLE SPECIFICATION
CONSULT
-
Ignition switch ON.
-
Perform writing Nissan Ariya vehicle specification to BCM according to "Replace ECU" in "CONSULT Operation Manual".
>>
Work End.
Other materials:
P0451 Barometric Pressure Sensor A/b
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0451
00
Barometric pressure sensor A/B
(EVAP System Pressure Sensor/Switch "A" Circuit Range/Performance
Diagnosis condition
—
Signal (terminal)
EVA ...
Symptom Diagnosis. All Doors Do Not Lock/unlock or Trunk/back Door Do Not Open with Request Switch
Description
All doors do not lock/unlock using door request switch.NOTE:
Before starting diagnosis check that vehicle condition is
as shown in “Conditions of Nissan Ariya vehicle”, and check each
symptom.
SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS) Door lock operation (re ...
Fuel Injector Relay
Component Inspection
CHECK FUEL INJECTOR RELAY
Turn ignition switch OFF.
Remove fuel injector relay. Refer to Component Parts Location.
Check the continuity between fuel injector relay terminals as per the following conditions.
Fuel injector relay Condition Continuity
+ −
...
