DIAGNOSIS AND REPAIR WORK FLOW
Work Flow
DETAILED FLOW
1.OBTAIN INFORMATION ABOUT SYMPTOM
Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurs.
>> GO TO 2.
2.CHECK SYMPTOM
>> GO TO 3.
3.DTC/SYSTEM DIGANOSIS
Perform a DTC/system diagnosis and repair or replace any malfunctioning part.
>> GO TO 4.
4.FINAL CHECK
Check that the SPORT mode functions normally.
Does it operation normally? YES >> End of trouble diagnosis NO >> GO TO 2.
Wiring diagram
DTC/circuit diagnosisUnit removal and installation
ENGINE ASSEMBLY
Exploded view
Engine mounting insulator (RH)
Upper torque rod (RH)
Engine mounting bracket (RH)
Lower torque rod
Torque rod bracket
Engine mounting insulator (LH)
Removal and installation (FWD)
WARNING:
Situate the vehicl ...
Inspection and adjustment
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Description
When replacing the occupant classification system control unit, perform
zero point reset procedure. Refer to
SRC-42, "ZERO POINT RESET : Special Repair Requirement".
When ...
P0507 ISC system
Description
The ECM controls the engine idle speed to a specified level through the fine
adjustment of the air, which is let
into the intake manifold, by operating the electric throttle control actuator.
The operating of the throttle valve is
varied to allow for optimum control of the engine ...