Nissan Rogue Service Manual: Inspection and adjustment
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement
INITIALIZATION PROCEDURE
Moonroof
If the moonroof does not open or close automatically, use the following procedure to return moonroof operation to normal.
- Turn ignition switch ON.
- Push and hold the moonroof switch forward until the moonroof and sunshade stop and bounce back.
- Release the moonroof switch.
- Press and hold the moonroof switch within 6 seconds.
- The roof glass and shade will move to full open and back to full close.
- Release the switch, initialization is complete if the moonroof operates normally.
ANTI-PINCH FUNCTION
Moonroof/Sunshade
- Fully open the moonroof to the full open position.
- Place a piece of wood at the fully closed position.
- Close the moonroof completely with auto-slide close function.
- Moonroof should make contact and then tilt up or travel in reverse.
CAUTION: • Do not test the anti-pinch function with your hands or other body parts because they may be pinched.
• Depending on the environment and driving conditions, if a similar impact or load is applied to the moonroof it may lower.
• Test the auto-slide operation before inspection when the initialization procedure is performed.
• Perform the initialization procedure when the auto-slide operation or anti-pinch function does not operate normally.
Diagnosis and repair workflow
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1. OBTAIN INFORMATION ABOUT SYMPTOM
Interview the customer to obtain as much information as possible about the
conditions and environment under
whic ...
Other materials:
U0102 lost communication (Transfer)
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
U0102
LOST COMM (TRANSFER)
(Lost Communication With Transfer Case Control
Module)
When the ignition switch is ON, TCM is unable to receive the CAN
...
C1130 engine signal
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
C1130
ENGINE SIGNAL 1
When a malfunction is detected in ECM system.
ECM
ABS actuator and electric unit
(control unit)
CAN communication l ...
Precautions when starting and driving
WARNING
Do not leave children or adults who
would normally require the assistance
of others alone in your vehicle. Pets
should also not be left alone. They
could accidentally injure themselves or
others through inadvertent operation of
the vehicle. Also, on h ...
