Nissan Rogue Service Manual: Basic inspection
CONFIGURATION (CAN GATEWAY)
Work Procedure
1.WRITING MODE SELECTION
CONSULT Configuration
Select “Re/programming, Configuration” of CAN gateway.
When writing saved data>>GO TO 2.
When writing manually>>GO TO 3.
2.PERFORM “AFTER REPLACE ECU” OF “READ / WRITE CONFIGURATION”
CONSULT Configuration
Perform “After Replace ECU” of “Read / Write Configuration”.
>> GO TO 4.
3.PERFORM “MANUAL CONFIGURATION”
CONSULT Configuration
- Select “Manual Configuration”.
- Touch “Next”.
- Touch “OK”.
- Check that the configuration has been successfully written and touch “End”.
>> GO TO 4.
4.CHECK ALL ECU SELF-DIAGNOSIS RESULTS
- Erase all ECU self-diagnosis results using CONSULT.
- Turn the ignition switch OFF.
- Turn the ignition switch ON and wait for 2 seconds or more.
- Check that all ECU self-diagnosis results have no DTC (e.g. U1000 and U1001) of CAN communication.
>> WORK END
ECU diagnosis information
CAN GATEWAY
Reference Value
VALUES ON THE DIAGNOSIS TOOL
NOTE:
The following table includes information (items) inapplicable to this vehicle.
For information (items) applicable
to this vehicle, ...
DTC/circuit diagnosis
B2600-46 CONFIG ERROR
DTC Description
DTC DETECTION LOGIC
DTC
Trouble diagnosis
(Trouble diagnosis contents)
Detecting condition
B2600-46
CONFIG ERROR
(Co ...
Other materials:
Diagnosis system (BCM) (with intelligent key system)
COMMON ITEM
COMMON ITEM : CONSULT Function (BCM - COMMON ITEM)
APPLICATION ITEM
CONSULT performs the following functions via CAN communication with BCM.
Direct Diagnostic Mode
Description
Ecu Identification
The BCM part number is displayed.
Self Diagnostic ...
Air conditioner operation
Start the engine, turn the fan control dial to the
desired position, and press the
button to
activate the air conditioner. When the air conditioner
is on, cooling and dehumidifying functions
are added to the heater operation.
The air conditioner cooling function operates
only when the engin ...
VDC off switch
Removal and Installation
REMOVAL
Remove the instrument lower panel LH. Refer to IP-14, "INSTRUMENT
PANEL ASSEMBLY : Removal
and Installation".
Release pawls using suitable tool and remove the VDC OFF switch
(2) from the upper switch carrier (1).
: Pawl
INST ...
