Nissan Rogue Service Manual: LAN System
- CAN fundamental
- CAN
- CAN gateway
- CAN system (type 1)
- CAN system (type 2)
- CAN system (type 3)
- CAN system (type 4)
- CAN system (type 5)
- CAN system (type 6)
- CAN system (type 7)
- CAN system (type 8)
Removal and installation
BCM (BODY CONTROL MODULE)
Removal and Installation
CAUTION:
Before replacing the BCM, perform “READ CONFIGURATION” to save or print current
vehicle specification.
Refer to BCS-120, "A ...
CAN fundamental
...
Other materials:
Hood
Hood
Pull the hood lock release handle 1 located
below the instrument panel until the hood
springs up slightly.
Locate the lever 2 in between the hood and
grille and push the lever sideways with your
fingertips.
Raise the hood 3 .
Remove the support rod 4 and in ...
Inspection and adjustment
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Description
When replacing the occupant classification system control unit, perform
zero point reset procedure. Refer to
SRC-42, "ZERO POINT RESET : Special Repair Requirement".
When ...
C1197 vacuum sensor
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
C1197
VACUUM SENSOR
When a malfunction is detected in vacuum sensor.
Harness or connector
Vacuum sensor (brake booster)
Vacuum piping
&nb ...
