Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Basic information

WARNING

Improper loading or overloading of a trailer can negatively impact vehicle handling, braking, and overall performance, increasing the risk of an accident.

CAUTION

  • Do not tow a trailer or haul heavy loads during the first 500 miles (800 km) of vehicle operation. Doing so may damage the engine, axle, or other components.
  • For the first 500 miles (800 km) of towing, do not exceed 50 MPH (80 km/h) and avoid full-throttle starts. This helps essential components in your Nissan Rogue adapt to the additional load.

Your vehicle is designed primarily for transporting passengers and cargo. Towing a trailer places extra stress on the engine, drivetrain, steering, braking, and other systems, so proper preparation is essential.

A NISSAN Towing Guide (U.S. only) is available at www.nissanusa.com. The guide provides important information on trailer towing capability and the required equipment for towing safely with the Nissan Rogue.

    Towing a trailer
    Maximum load limits
    Maximum trailer loads Never allow the total trailer load to exceed the value listed in the “Towing Load/Specification” chart in this section. The total trailer load is the c...

    Other materials:

    System
    Meter System System Description SYSTEM DIAGRAM Parts name Description Ambient sensor Refer to Ambient Sensor. BCM Transmits the BCM status to the combination meter via CAN communication. Combination meter Refer to Combination Meter. ECM Transmits the ECM status to ...

    Component Parts
    Nissanconnect with 8" Color Display Component Parts Location No. Component Function 1. Rear door speaker RH Refer to Speaker. 2. Microphone Refer to Microphone. 3. Front door speaker RH Refer to Speaker. 4. Front speaker RH 5. Front speaker LH ...

    How to Erase Permanent Dtc
    Description OUTLINEWhen a DTC is stored in control moduleWhen a DTC is stored in control module and MIL is ON, a permanent DTC is erased with MIL shutoff if the same malfunction is not detected after performing the driving pattern for MIL shutoff three times in a raw. *1: When the same mal ...