Nissan Rogue (T33) 2021-Present Service Manual: B2756-94 Rear Sensor
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| B2756-94 |
Rear sensor (Rear sensor) |
Diagnosis condition | When ignition switch is ON |
| Signal (terminal) | Rear sensor signal | ||
| Threshold | Persistent noise | ||
| Diagnosis delay time | 1 seconds or more | ||
POSSIBLE CAUSE
Persistent noise in the rear sensors ultrasonic range (exhaust sound, heavy rain, horn) not filtered out by signal processing.
FAIL-SAFE
Obstacle detection function is deactivated.
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait for 30 seconds.
-
Turn ignition switch ON and wait at least 2 seconds or more.
-
Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.
-
Check DTC.
Is DTC B2756-94 detected?
YES>>Proceed to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
CHECK REAR SENSORS
Check the rear sensor for dirt and damage.
Is inspection result normal?
YES>>GO TO 2.
NO>>PERFORM DTC CONFIRMATION PROCEDURE AGAIN
With CONSULT
-
Turn ignition switch ON.
-
Erase DTC.
-
Perform DTC confirmation procedure again. Refer to DTC Description.
Is DTC B2756-94 detected again?
YES>>Replace rear sensors. Refer to Removal and Installation.
NO>>INSPECTION END
Other materials:
Difference between predictive and actual distances
Basic information
The displayed guide lines and their positions on the ground are intended only as approximate references. When driving the Nissan Rogue on uphill, downhill, or uneven surfaces, or when objects extend outward, the actual distance may differ from what appears on the monitor relative t ...
C1f80-55 Steering Wheel Touch Sensor
Without Propilot Assist 2.1
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C1F80
55
Steering wheel touch sensor
(Steering wheel touch sensor)
Diagnosis condition
When engine is running
Signal (terminal)
...
Engine Stand Setting
Setting
NOTE:
Explained here is how to disassemble with engine stand
supporting transaxle surface. When using different type of engine stand,
note with difference in steps and etc.
Remove the engine and the transaxle assembly from the
vehicle, and separate the transaxle from the engine. Ref ...
