Nissan Rogue (T33) 2021-Present Service Manual: B2731-13 Side Sensor [rr]

Nissan Rogue (T33) 2021-Present Service Manual / Driver Information & Multimedia :: Sonar System / Dtc/circuit Diagnosis :: Sonar (sonar Control Unit) / B2731-13 Side Sensor [rr]

DTC Description

DTC DETECTION LOGIC

DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition
B2731-13

SIDE SENSOR [RR]

(Side sensor [RR]) 		Diagnosis condition When ignition switch is ON
Signal (terminal) Rear sonar sensor signal RH side
Threshold Harness open
Diagnosis delay time 4 seconds or more

POSSIBLE CAUSE

  • Harness and connector between sonar control unit and rear sonar sensor RH side

  • Rear sonar sensor RH side

FAIL-SAFE

Stop the obstacle detection function

CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Turn ignition switch ON.

  2. Turn ignition switch OFF and wait at least 30 seconds.

  3. Turn ignition switch ON and wait at least 30 seconds or more.

  4. Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.

  5. Check the DTC.

Is DTC “B2731–13” detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK REAR SONAR SENSOR SIGNAL RH SIDE CIRCUIT (OPEN)

  1. Turn ignition switch OFF.

  2. Disconnect sonar control unit connector and rear sonar sensor RH side connector.

  3. Check continuity between sonar control unit harness connector and rear sonar sensor RH side connector.

    Sonar control unit Rear sonar sensor RH side Continuity
    Connector Terminal Connector Terminal
    B49 50 B464 2 Existed

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair the harness or connector.

CHECK REAR SONAR SENSOR RH SIDE GROUND CIRCUIT

Check continuity between sonar control unit harness connector and rear sonar sensor RH side harness connector.

Sonar control unit Rear sonar sensor RH side Continuity
Connector Terminal Connector Terminal
B20 14 B464 3 Existed

Is the inspection result normal?

YES>>

Replace the rear sonar sensor RH side. Refer to Removal and Installation.

NO>>

Repair the harness or connector.

    B2731-12 Side Sensor [rr]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B2731-12 SIDE SENSOR [RR] (Side sensor [RR]) Diagnosis condition...
    B2731-16 Side Sensor [rr]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B2731-16 SIDE SENSOR [RR] (Side sensor [RR]) Diagnosis condition...

    Other materials:

    Symptom Diagnosis. Intelligent Key Low Battery Warning Does Not Operate
    Diagnosis Procedure CHECK INFORMATION DISPLAY Check information display. Refer to Work flow. Is the inspection result normal? YES>> GO TO 2. NO>> Repair or replace the malfunctioning parts. CHECK INTELLIGENT KEY BATTERY Check Intelligent Key battery. Refer to Component Inspe ...

    Power Supply and Ground Circuit
    Ecm Diagnosis Procedure CHECK THE BATTERY CABLE Turn ignition switch OFF. Check the battery cable for tightening enough. NOTE: Check the continuity between the battery cable and the battery terminal. Is the inspection result normal? YES>> GO TO 2 ...

    Symptom Diagnosis. Squeak and Rattle Trouble Diagnoses
    Work Flow CUSTOMER INTERVIEWInterview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any of customer's comments; Refer to Diagnostic Work ...