Nissan Rogue (T33) 2021-Present Service Manual: B2731-12 Side Sensor [rr]
DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen items (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| B2731-12 |
SIDE SENSOR [RR] (Side sensor [RR]) |
Diagnosis condition | When ignition switch is ON | |
| Signal (terminal) | Rear sonar sensor signal RH side | |||
| Threshold | Short circuit to power supply | |||
| Diagnosis delay time | 4 seconds or more | |||
POSSIBLE CAUSE
-
Harness and connector between sonar control unit and rear sonar sensor RH side
-
Rear sonar sensor RH side
FAIL-SAFE
Stop the obstacle detection function
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 30 seconds.
-
Turn ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.
-
Check the DTC.
Is DTC “B2731–12” detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
CHECK REAR SONAR SENSOR SIGNAL RH SIDE CIRCUIT (1)
-
Turn ignition switch OFF.
-
Disconnect sonar control unit connector and rear sonar sensor RH side connector.
-
Turn ignition switch ON.
-
Check voltage between sonar control unit harness connector and ground.
Sonar control unit (-) Voltage (Approx. ) Connector Terminal B49 50 Ground 0 V
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair harness or connector.
CHECK REAR SONAR SENSOR SIGNAL RH SIDE CIRCUIT (2)
-
Turn ignition switch OFF.
-
Check continuity between rear sonar sensor RH side harness connector and ground.
| Rear sonar sensor RH side | Ground | Continuity | |
| Connector | Terminal | ||
| B464 | 2 | Not existed | |
Is the inspection result normal?
YES>>Replace the rear sonar sensor RH side. Refer to Removal and Installation.
NO>>Repair the harness or connector.
Other materials:
Lane Branch Line Circuit
Diagnosis Procedure
CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the front camera unitfor damage, bend and loose connection (unit side and connector side).
Is the inspection result no ...
Removal and Installation. Tire Pressure Sensor
Exploded View
Screw
Tire pressure sensor
Valve
Valve core
Valve cap
: Comply with the assembly procedure when tightening. Refer to Removal and Installation.
: N·m (kg-m, in-lb)
: Always replace after every disassembly.
Removal & Install ...
U2a8c-88 Ethernet Circuit
DTC Description
DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition
U2A8C-88
Ethernet circuit
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
—
Threshold
Lost ethernet communication with AV control unit
Diagnosis delay time ...
