Nissan Rogue (T33) 2021-Present Service Manual: B2730-83 Side Sensor [rl]
DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen items (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| B2730-83 |
SIDE SENSOR [RL] (Side sensor [RL]) |
Diagnosis condition | When ignition switch is ON | |
| Signal (terminal) | Rear sonar sensor signal LH side | |||
| Threshold | An abnormal sensor signal is input from sonar sensor | |||
| Diagnosis delay time | 4 seconds or more | |||
POSSIBLE CAUSE
Rear sonar sensor LH side
FAIL-SAFE
Stop the obstacle detection function
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 30 seconds.
-
Turn ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.
-
Check the DTC.
Is DTC “B2730–83” detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
With CONSULT
-
Turn ignition switch ON.
-
Erase DTC.
-
Perform DTC confirmation procedure again. Refer to DTC Description.
Is DTC B2730-83 detected again?
YES>>Replace the rear sonar sensor LH side. Refer to Removal and Installation.
NO>>INSPECTION END
Other materials:
P1c90-49 Sub Starter & Generator
DTC Description
DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition
P1C90-49
Sub starter & generator
(Sub starter & generator)
Diagnosis condition
Engine running at idle
Signal (terminal)
-
Threshold
Sub starte ...
B2730-13 Side Sensor [rl]
DTC Description
DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition
B2730-13
SIDE SENSOR [RL]
(Side sensor [RL])
Diagnosis condition
When ignition switch is ON
Signal (terminal)
Rear sonar sensor signal LH side
Threshold
H ...
Chassis Can Communication 4 Circuit
Diagnosis Procedure
CHECK NETWORK DIAGNOSIS
Check the "Network diagnosis" results from CONSULT to see that the diagnostic CAN communication circuit have no malfunction.
Are the diagnostic CAN communication circuit normal?
YES>>
GO TO 2.
NO>>
Check and repair diagnostic CAN commu ...
