Nissan Rogue (T33) 2021-Present Service Manual: B272b-12 Center Sensor [fr]
DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen items (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| B272B-12 |
CENTER SENSOR [FR] (Center sensor [FR]) |
Diagnosis condition | When ignition switch is ON | |
| Signal (terminal) | Front sonar sensor signal RH inner | |||
| Threshold | Short circuit to power supply | |||
| Diagnosis delay time | 4 seconds or more | |||
POSSIBLE CAUSE
-
Harness and connector between sonar control unit and front sonar sensor RH inner
-
Front sonar sensor RH inner
FAIL-SAFE
Stop the obstacle detection function
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 30 seconds.
-
Turn ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.
-
Check the DTC.
Is DTC “B272B–12” detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
CHECK FRONT SONAR SENSOR SIGNAL RH INNER CIRCUIT (1)
-
Turn ignition switch OFF.
-
Disconnect sonar control unit connector and front sonar sensor RH inner connector.
-
Turn ignition switch ON.
-
Check voltage between sonar control unit harness connector and ground.
Sonar control unit (-) Voltage (Approx. ) Connector Terminal B20 1 Ground 0 V
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair harness or connector.
CHECK FRONT SONAR SENSOR SIGNAL RH INNER CIRCUIT (2)
-
Turn ignition switch OFF.
-
Check continuity between front sonar sensor RH inner harness connector and ground.
| Front sonar sensor RH inner | Ground | Continuity | |
| Connector | Terminal | ||
| E306 | 2 | Not existed | |
Is the inspection result normal?
YES>>Replace the front sonar sensor RH inner. Refer to Removal and Installation.
NO>>Repair the harness or connector.
Other materials:
Heated steering wheel
Example
Push the heated steering wheel switch to warm the steering wheel after the engine starts. The indicator light A will illuminate once the system is active.
If the steering wheel surface temperature is below 86–104ºF (30–40ºC), the system will automatically heat the wheel and cycle o ...
Chassis control
Basic information
The chassis control system in the Nissan Rogue uses an electric control module that manages the following functions:
Intelligent Trace Control
Active Ride Control (if so equipped)
Intelligent Trace Control
This feature analyzes the driver’s steering, acceleration and braking ...
C1f59-04 Eps Circuit
Without Propilot Assist 2.1
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C1F59
04
EPS control unit
(Electric power steering control unit)
Diagnosis condition
When engine is running
Signal (termi ...
