Nissan Rogue (T33) 2021-Present Service Manual: B272a-34 Center Sensor [fl]

Nissan Rogue (T33) 2021-Present Service Manual / Driver Information & Multimedia :: Sonar System / Dtc/circuit Diagnosis :: Sonar (sonar Control Unit) / B272a-34 Center Sensor [fl]

DTC Description

DTC DETECTION LOGIC

DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition
B272A-34

CENTER SENSOR [FL]

(Center sensor [FL]) 		Diagnosis condition When ignition switch is ON
Signal (terminal) Front sonar sensor signal LH inner
Threshold An abnormal sensor signal is input from sonar sensor (Pulse signal high side is short)
Diagnosis delay time 4 seconds or more

POSSIBLE CAUSE

  • Harness and connector between sonar control unit and front sonar sensor LH inner

  • Front sonar sensor LH inner

FAIL-SAFE

Stop the obstacle detection function

CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Turn ignition switch ON.

  2. Turn ignition switch OFF and wait at least 30 seconds.

  3. Turn ignition switch ON and wait at least 30 seconds or more.

  4. Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.

  5. Check the DTC.

Is DTC “B272A–34” detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK FRONT SONAR SENSOR SIGNAL LH INNER CIRCUIT (OPEN)

  1. Turn ignition switch OFF.

  2. Disconnect sonar control unit connector and front sonar sensor LH inner connector.

  3. Check continuity between sonar control unit harness connector and front sonar sensor LH inner connector

    Sonar control unit Front sonar sensor LH inner Continuity
    Connector Terminal Connector Terminal
    B20 2 E305 2 Existed

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair the harness or connector.

CHECK FRONT SONAR SENSOR LH INNER GROUND CIRCUIT

Check continuity between sonar control unit harness connector and front sonar sensor LH inner harness connector.

Sonar control unit Front sonar sensor LH inner Continuity
Connector Terminal Connector Terminal
B20 13 E305 3 Existed

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair the harness or connector.

CHECK FRONT SONAR SENSOR SIGNAL LH INNER

  1. Connect sonar control unit connector and front sonar sensor LH inner connector.

  2. Turn ignition switch ON.

  3. Check the signal between sonar control unit terminals as per the following condition.

    + − Condition Voltage
    Sonar control unit
    Connector Terminal Connector Terminal
    B20 2 B20 13

    • Shift position is in R position.

    • When the sensor is detecting an obstacle

Is the inspection result normal?

YES>>

Replace the sonar control unit. Refer to Removal and Installation.

NO>>

Replace the front sonar sensor LH inner. Refer to Removal and Installation.

    B272a-17 Center Sensor [fl]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B272A-17 CENTER SENSOR [FL] (Center sensor [FL]) Diagnosis condi...
    B272a-43 Center Sensor [fl]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B272A-43 CENTER SENSOR [FL] (Center sensor [FL]) Diagnosis condi...

    Other materials:

    Dtc/circuit Diagnosis. Horn Function
    Component Function Check CHECK FUNCTION CONSULT Ignition switch OFF. Perform “Horn” in “Active test” mode of “IPDM E/R”. Check the horn operation. Test item Description Horn On Horn Sounds (for 20 ms.) Is the operation normal? YES>> Ins ...

    Dtc/circuit Diagnosis. B1002-13 Lap Pre-Tensioner Rh
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B1002-13 Lap pre-tensioner RH (Lap pre-tensioner right hand) Diagnosis condition When ignition switch is ON. Signal (terminal) Lap pre-tensioner RH signal ...

    Dtc/circuit Diagnosis. B2428-46 Automatic Back Door Control Unit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B2428-46 Automatic back door control unit (Automatic back door control unit) Diagnosis condition All times Signal (terminal) — Threshold Automatic ...