Nissan Rogue (T33) 2021-Present Service Manual: B2723-65 Corner Sensor [rr]
DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen items (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| B2723-65 |
CORNER SENSOR [RR] (Corner sensor [RR]) |
Diagnosis condition | When ignition switch is ON | |
| Signal (terminal) | — | |||
| Threshold | Sonar sensor temperature is high | |||
| Diagnosis delay time | 4 seconds or more | |||
POSSIBLE CAUSE
-
Sonar sensor temperature is high
-
Rear sonar sensor RH outer
FAIL-SAFE
Stop the obstacle detection function
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 30 seconds.
-
Turn ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.
-
Check the DTC.
Is DTC “B2723–65” detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
CHECK SONAR SENSOR
Check whether there is any factor which causes a temperature rise near sonar sensor.
Was there any factor?
YES>>Remove a factor.
NO>>GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
With CONSULT
-
Turn ignition switch ON.
-
Erase DTC.
-
Perform DTC confirmation procedure again. Refer to DTC Description.
Is DTC B2723-65 detected again?
YES>>Replace the rear sonar sensor RH outer. Refer to Removal and Installation.
NO>>INSPECTION END
Other materials:
P0106 Manifold Absolute Pressure Sensor
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0106
00
ABSL PRES SEN/CIRC
(Manifold Absolute Pressure/Barometric Pressure Sensor Circuit Range/Performance)
Diagnosis condition
—
Signal (terminal)
...
Removal and Installation. Tire Pressure Sensor
Exploded View
Screw
Tire pressure sensor
Valve
Valve core
Valve cap
: Comply with the assembly procedure when tightening. Refer to Removal and Installation.
: N·m (kg-m, in-lb)
: Always replace after every disassembly.
Removal & Install ...
Power Supply and Ground Circuit
Ecm
Diagnosis Procedure
CHECK THE BATTERY CABLE
Turn ignition switch OFF.
Check the battery cable for tightening enough.
NOTE:
Check the continuity between the battery cable and the battery terminal.
Is the inspection result normal?
YES>>
GO TO 2
...