Nissan Rogue (T33) 2021-Present Service Manual: B2723-12 Corner Sensor [rr]
DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen items (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| B2723-12 |
CORNER SENSOR [RR] (Corner sensor [RR]) |
Diagnosis condition | When ignition switch is ON | |
| Signal (terminal) | Rear sonar sensor signal RH outer | |||
| Threshold | Short circuit to power supply | |||
| Diagnosis delay time | 4 seconds or more | |||
POSSIBLE CAUSE
-
Harness and connector between sonar control unit and rear sonar sensor RH outer
-
Rear sonar sensor RH outer
FAIL-SAFE
Stop the obstacle detection function
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 30 seconds.
-
Turn ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.
-
Check the DTC.
Is DTC “B2723–12” detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
CHECK REAR SONAR SENSOR SIGNAL RH OUTER CIRCUIT (1)
-
Turn ignition switch OFF.
-
Disconnect sonar control unit connector and rear sonar sensor RH outer connector.
-
Turn ignition switch ON.
-
Check voltage between sonar control unit harness connector and ground.
Sonar control unit (-) Voltage (Approx. ) Connector Terminal B20 10 Ground 0 V
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair harness or connector.
CHECK REAR SONAR SENSOR SIGNAL RH OUTER CIRCUIT (2)
-
Turn ignition switch OFF.
-
Check continuity between rear sonar sensor RH outer harness connector and ground.
| Rear sonar sensor RH outer | Ground | Continuity | |
| Connector | Terminal | ||
| B460 | 2 | Not existed | |
Is the inspection result normal?
YES>>Replace the rear sonar sensor RH outer. Refer to Removal and Installation.
NO>>Repair the harness or connector.
Other materials:
Brake fluid
For more information on brake fluid type and capacity, refer to “Capacities and recommended fluids/lubricants”.
WARNING
Always use new brake fluid from a sealed container. Contaminated, old, or poor-quality fluid may damage the brake system and reduce stopping performance.
Clean the filler c ...
B24a4-11 Intake Sensor
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
B24A4-11
INTAKE SENSOR
(Intake sensor)
Diagnosis condition
Ignition switch ON
Signal (Terminal)
Intake sensor signal
Threshold
The intake sensor rec ...
Lane Branch Line Circuit
Diagnosis Procedure
CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the front camera unitfor damage, bend and loose connection (unit side and connector side).
Is the inspection result no ...
