Nissan Rogue Service Manual: Symptom diagnosis

Nissan Rogue Service Manual / Driver controls / Interior Lighting System / Symptom diagnosis

INTERIOR LIGHTING SYSTEM SYMPTOMS

Symptom Table

CAUTION: Perform the self-diagnosis with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected.

Symptom	Possible cause	Inspection item
All the following lamps do not turn ON. Map lamp Room lamp Luggage room lamp	Harness between BCM and each interior room lamp BCM	Interior room lamp power supply circuit Refer to INL-46.
Interior room lamp does not turn ON even though the door is open. (It turns ON when turning the interior room lamp ON.) Interior room lamp does not turn OFF even though the door is closed.	Harness between BCM and each door switch Harness between BCM and each interior room lamp BCM	Door switch circuit Refer to DLK-149, "Component Function Check" (with Intelligent Key system) or DLK-319, "Component Function Check" (without Intelligent Key system). Interior room lamp control circuit Refer to INL-49.
Interior room lamp timer does not activate. (It turns ON/ OFF when the door opens/closes.)	—	Check the interior room lamp setting. Refer to INL-9, "INTERIOR ROOM LAMP BATTERY SAVER SYSTEM : System Description".
Luggage room lamp does not turn ON even though the back door is open. Luggage room lamp does not turn OFF even though the back door is closed.	Harness between BCM and back door switch Harness between BCM and luggage room lamp BCM	Back door switch circuit Refer to DLK-151, "Component Function Check" (with Intelligent Key system) or DLK-319, "Component Function Check" (without Intelligent Key system).
		Luggage room lamp circuit Refer to INL-51.
Power switch illumination does not illuminate.	Harness between BCM and power switch BCM	Power switch illumination circuit Refer to INL-52.
Interior room lamp battery saver does not activate.	BCM	Replace BCM. Refer to BCS-75, "Removal and Installation" (with Intelligent Key system) or BCS-135, "Removal and Installation" (without Intelligent Key system).

Power switch illumination circuit

Description Provides the power supply and the ground to control the power switch illumination. Component Function Check 1.CHECK POWER SWITCH ILLUMINATION OPERATION CONSULT ACTIVE TEST ...

Removal and installation

...

Other materials:

Symptom diagnosis
SQUEAK AND RATTLE TROUBLE DIAGNOSES Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any customer& ...

C1121, C1123, C1125, C1127 ABS out valve system
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1121 FR LH OUT ABS SOL When a malfunction is detected in front LH ABS OUT valve. Harness or connector ABS actuator and electric unit (control u ...

Component parts
Component Parts Location Instrument panel View with drivers door finisher removed View with center console removed View with the lower B-pillar trim removed View with the lower B-pillar trim removed View with LH rear lower luggage finisher remove ...