Nissan Rogue Service Manual: Precaution

Nissan Rogue Service Manual / Electrical & power control / Power Control System / Power distribution system / Precaution

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"

The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system safely is included in the SR and SB section of this Service Manual.

WARNING:

To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance must be performed by an authorized NISSAN/INFINITI dealer.
Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag Module, see the SR section.
Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors.

PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS

WARNING:

When working near the Airbag Diagnosis Sensor Unit or other Airbag System sensors with the Ignition ON or engine running, DO NOT use air or electric power tools or strike near the sensor(s) with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing serious injury.
When using air or electric power tools or hammers, always switch the Ignition OFF, disconnect the battery and wait at least three minutes before performing any service.

Power distribution system

...

System description

COMPONENT PARTS Component Parts Location No. Component Description 1 Push-button ignition switch1 Push-button ignition switch (push switch) is pressed ...

Other materials:

C1121, C1123, C1125, C1127 ABS out valve system
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1121 FR LH OUT ABS SOL When a malfunction is detected in front LH ABS OUT valve. Harness or connector ABS actuator and electric unit (control u ...

S connector circuit
Description The starter motor magnetic switch is supplied with power when the ignition switch is turned to the START position while the selector lever is in the P (Park) or N (Neutral) position. Diagnosis Procedure Regarding Wiring Diagram information, refer to STR-7, "Wiring Diagram" ...

Periodic maintenance
REAR PROPELLER SHAFT Inspection APPEARANCE AND NOISE Check the propeller shaft tube surface for dents or cracks. If malfunction is detected, replace propeller shaft assembly. If center bearing is noisy or damaged, replace propeller shaft assembly. VIBRATION If vibrati ...