Nissan Rogue Service Manual: Power window control system symptoms

Nissan Rogue Service Manual / Body exterior, doors, roof & vehicle security / Power Window Control System / Symptom diagnosis / Power window control system symptoms

Symptom Table

Symptom	Reference page
None of the power windows can be operated using any switch.	Refer to PWC-55, "Diagnosis Procedure".
Driver side power window alone does not operate.	Refer to PWC-56, "Diagnosis Procedure".
Front passenger side power window does not operate (with both power window main switch and front passenger side power window switch).	Refer to PWC-57, "WITH BOTH POWER WINDOW MAIN SWITCH AND FRONT PASSENGER SIDE POWER WINDOW SWITCH : Diagnosis Procedure".
Front passenger side power window does not operate (with front power window switch only).	Refer to PWC-57, "WITH FRONT POWER WINDOW SWITCH ONLY : Diagnosis Procedure".
Rear LH side power window does not operate (with both power window main switch and rear power window switch LH).	Refer to PWC-58, "WITH BOTH POWER WINDOW MAIN SWITCH AND REAR POWER WINDOW SWITCH LH : Diagnosis Procedure".
Rear LH side power window does not operate (with rear power window switch LH only).	Refer to PWC-58, "WITH REAR POWER WINDOW SWITCH LH ONLY : Diagnosis Procedure".
Rear RH side power window does not operate (with both power window main switch and rear power window switch RH).	Refer to PWC-59, "WITH BOTH POWER WINDOW MAIN SWITCH AND REAR POWER WINDOW SWITCH RH : Diagnosis Procedure".
Rear RH side power window does not operate (with rear power window switch RH only).	Refer to PWC-59, "WITH REAR POWER WINDOW SWITCH RH ONLY : Diagnosis Procedure".
Anti-pinch system does not operate normally (drivers side).	Refer to PWC-60, "Diagnosis Procedure".
Power window retained power operation does not operate prope	Refer to PWC-61, "Diagnosis Procedure".
Auto operation does not operate manual operate normally (driver side).	Refer to PWC-62, "Diagnosis Procedure".
Power window lock switch does not function.	Refer to PWC-63, "Diagnosis Procedure".

Symptom diagnosis

...

None of the power windows can be operated using any switch

Diagnosis Procedure 1.CHECK BCM POWER SUPPLY AND GROUND CIRCUIT Check BCM power supply and ground circuit. Refer to BCS-68, "Diagnosis Procedure" (with Intelligent Key system) or BCS-12 ...

Other materials:

Normal operating condition
Description FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED) If the engine speed is above 1,800 rpm under no load (for example, the selector lever position is neutral and engine speed is over 1,800 rpm) fuel will be cut off after some time. The exact time when the fuel is cut off varies b ...

On board refueling vapor recovery (ORVR)
Component Function Check 1.CHECK ORVR FUNCTION Check whether the following symptoms are present. Fuel odor from EVAP canister is strong. Cannot refuel/Fuel odor from the fuel filler opening is strong while refueling. Are any symptoms present? YES >> Proceed to EC-477 ...

System description
COMPONENT PARTS Component Parts Location No. Component Function 1 Combination meter Combination meter transmits the vehicle speed signal to BCM via CAN communication. BCM also receives the vehicle speed signal from ABS actuator and electric ...