Nissan Rogue Owners Manual: Warning/indicator lights and audible reminders
 |
Anti-lock Braking System (ABS) warning light |
 |
Brake warning light |
 |
Charge warning light |
 |
Low tire pressure warning light |
 |
Low windshield washer fluid warning light (if so equipped) |
 |
Master warning light |
 |
Power steering warning light |
 |
Seat belt warning light and chime |
 |
Supplemental air bag warning light |
 |
All-Wheel Drive (AWD) AUTO indicator light (if so equipped) |
 |
All-Wheel Drive (AWD) LOCK indicator light (if so equipped) |
 |
ECO Mode indicator light |
 |
Front fog light indicator light (if so equipped) |
 |
Front passenger air bag status light |
 |
High beam indicator light (blue) |
 |
Hill descent indicator light (if so equipped) |
 |
Malfunction Indicator Light (MIL) |
 |
Overdrive off indicator light |
 |
Security indicator light |
 |
Slip indicator light |
 |
Sport mode indicator light |
 |
Turn signal/hazard indicator lights |
 |
Vehicle Dynamic Control (VDC) off indicator light |
Checking bulbs
With all doors closed, apply the parking brake and place the ignition switch to the ON position without starting the engine. The following lights will come on:
, or
,
,
,
The following lights come on briefly and then go off:
,
,
,
,
,
If any light fails to come on, it may indicate a burned-out bulb or an open circuit in the electrical system. Have the system repaired promptly.
Fuel gauge
Fuel gauge
The gauge indicates the approximate fuel level
in the tank.
The gauge may move slightly during braking,
turning, acceleration, or going up or down hills.
The gauge needle returns ...
Warning lights
For additional information on warnings and indicators,
refer to “Vehicle information display” in
this section.
Anti-lock
Braking System (ABS) warning lig
When the ignition switch is pl ...
Other materials:
System
FRONT WIPER AND WASHER SYSTEM
FRONT WIPER AND WASHER SYSTEM : System Diagram
FRONT WIPER AND WASHER SYSTEM : System Description
OUTLINE
FRONT WIPER CONTROL (BASIC)
BCM detects the combination switch position by the combination
switch reading function.
BCM transmits the f ...
System
System Description
When the vehicle has reached a speed of 40 km/h (25 MPH) or greater, the BCM
receives a signal transmitted
from the tire pressure sensors installed in each wheel. If the BCM detects low
inflation pressure or a system
malfunction, it sends a signal to the combination meter v ...
U1000 CAN COMM circuit
DTC Logic
DTC DETECTION LOGIC
DTC
CONSULT
Detection Condition
Possible Cause
U1000
CAN COMM CIRC
[U1000]
When combination meter is not transmitting or receiving CAN
communication signals for 2 seconds or more.
CAN communication system
D ...
