Nissan Rogue (T33) 2021-Present Service Manual: U2e52-57 Mac Comm Error (ecm)

Nissan Rogue (T33) 2021-Present Service Manual / Cruise Control & Driver Assistance :: Driver Assistance System / Chassis Control :: Dtc/circuit Diagnosis / U2e52-57 Mac Comm Error (ecm)

DTC Description

DTC DETECTION LOGIC

DTC No. CONSULT screen terms DTC detection condition
U2E52 57 CAN communication error (ADAS control unit) Diagnosis condition —
Signal (terminal) —
Threshold MAC communication error.
Diagnosis delay time —

POSSIBLE CAUSE

  • Chassis control module used in vehicles is installed in the vehicle

  • Chassis control module

  • ADAS control unit 2

FAIL-SAFE

-

DTC CONFIRMATION PROCEDURE

CHECK DTC PRIORITY

If DTC “U2140-57” is displayed with DTC “U1327-52” or “U1327-54”, first perform the trouble diagnosis for DTC “U1327-52” or “U1327-54”.

Is DTC “U1327-52” or “U1327-54” detected?

YES>>

  • “U1327-52”: Refer to DTC Description.

  • “U1327-54”: Refer to DTC Description.

NO>>

GO TO 2.

CHECK MAC DIAGNOSIS

With CONSULT

  1. Ignition switch ON.

  2. Perform “MAC Diagnosis” mode of “CHASSIS CONTROL” using CONSULT.

Is DTC “U2E52-57” detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK DTC PRIORITY

If DTC “U2140-57” is displayed with DTC “U1327-52” or “U1327-54”, first perform the trouble diagnosis for DTC “U1327-52” or “U1327-54”.

Is DTC “U1327-52” or “U1327-54” detected?

YES>>

  • “U1327-52”: Refer to DTC Description.

  • “U1327-54”: Refer to DTC Description.

NO>>

GO TO 2.

CHECK MAC DIAGNOSIS

With CONSULT

Perform “MAC Diagnosis” mode of “CHASSIS CONTROL” using CONSULT.

Is DTC "U2E52-57" detected with "U2140-57", "U2141-57", "U214F-57", "U2152-57", "U2165-57", "U2E65-57", and "U2E75-57" at the same time?

YES (all DTC codes are detected at the same time)>>

Replace the chassis control module. Refer to Removal and Installation.

NO (all DTC codes are not detected at the same time)>>

GO TO 3.

CHECK CAN COMMUNICATION SYSTEM

Check CAN communication system. Refer to Trouble Diagnosis Flow Chart.

>>

INSPECTION END

    U2a17-88 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition U2A17 88 CAN Bus Off 7 1 Diagnosis condition When ignition switch is ON. Signal (termina...
    U2e52-83 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition U2E52 83 CAN communication error (ADAS control unit) Diagnosis condition When ignition s...

    Other materials:

    U224a-87 Can Comm Err (awd/4wd)
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U224A 87 CAN comm err (AWD/4WD) [Controller area network communication error (AWD/4WD control unit)] 1 Diagnosis condition When ignition switch is ON. ...

    C0513 Wheel Speed Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition C0513 00 Right rear wheel speed sensor (Right Rear Wheel Speed Sensor Range/Performance) Diagnosis condition Ignition switch ON Battery voltage: 11 V ...

    C1f59-04 Eps Circuit
    Without Propilot Assist 2.1 DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition   C1F59 04 EPS control unit (Electric power steering control unit) Diagnosis condition When engine is running Signal (termi ...