Description
Initial diagnosis of combination meter.
DTC Logic
DTC DETECTION LOGIC
|
DTC |
CONSULT |
Detection Condition |
Possible Cause |
| U1010 | CONTROL UNIT (CAN) [U1010] | When detecting error during the initial diagnosis of the CAN controller of combination meter. | Combination meter |
Diagnosis Procedure
1.REPLACE COMBINATION METER
When DTC "U1010" is detected, replace combination meter.
>> Replace combination meter. Refer to MWI-82, "Removal and Installation".
U1000 CAN COMM circuit
B2205 vehicle speedFuel pressure
Work Procedure
FUEL PRESSURE RELEASE
1.FUEL PRESSURE RELEASE
With CONSULT
Turn ignition switch ON.
Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode of “ENGINE”
using CONSULT.
Start engine.
After engine stalls, crank it two or three times to ...
Front passenger air bag module
Exploded View
Front passenger air bag module
Steering member
Removal and Installation
WARNING:
Before servicing the SRS, turn ignition switch OFF, disconnect
both battery terminals then wait at
least three minutes.
Always work from the side of air bag module. Do ...
iPod®* player operation without Navigation System (if so equipped)
iPod®* player operation without Navigation System
Connecting iPod
WARNINGDo not connect, disconnect, or operate the
USB device while driving. Doing so can be
a distraction. If distracted you could lose
control of your vehicle and cause an accident
or serious injury.
& ...