Nissan Rogue Service Manual: B2205 vehicle speed

Nissan Rogue Service Manual / Driver information & multimedia / Meter, Warning Lamp & Indicator / DTC/circuit diagnosis / B2205 vehicle speed

Description

Vehicle speed signal is transmitted from ABS actuator and electric unit (control unit) via CAN communication line to combination meter.

DTC Logic

DTC DETECTION LOGIC

DTC	CONSULT	Detection Condition	Possible Cause
B2205	VEHICLE SPEED CIRC [B2205]	Malfunction is detected when an erroneous speed signal is received for 2 seconds or more.	Combination meter ABS actuator and electric unit (control unit)

Diagnosis Procedure

1.CHECK COMBINATION METER INPUT SIGNAL

Start engine and select “METER/M&A” on CONSULT.
Using ”SPEED METER” on ”Data Monitor”, compare the value of Data Monitor with speedometer pointer of combination meter. Speedometer and Data Monitor indications should be close.

Is the inspection result normal? YES >> Perform “Self Diagnostic Result” of “ABS” Refer to BRC-44, "CONSULT Function".

NO >> Replace combination meter. Refer to MWI-82, "Removal and Installation".

U1010 control unit (CAN)

Description Initial diagnosis of combination meter. DTC Logic DTC DETECTION LOGIC DTC CONSULT Detection Condition Possible Cause U1010 CONTROL UNIT (CAN ...

B2267 engine speed

Description The engine speed signal is transmitted from ECM to the combination meter with CAN communication. DTC Logic DTC DETECTION LOGIC DTC CONSULT Detection Conditio ...

Other materials:

Power window motor
DRIVER SIDE DRIVER SIDE : Description Door glass moves UP/DOWN by receiving the signal from main power window and door lock/unlock switch. DRIVER SIDE : Component Function Check 1. CHECK FRONT POWER WINDOW MOTOR LH OPERATION Check front power window motor LH operation with main power window a ...

Periodic maintenance
IDLE SPEED Inspection 1.CHECK IDLE SPEED With CONSULT Check idle speed in “DATA MONITOR” mode of “ENGINE” using CONSULT. With GST Check idle speed with Service $01 of GST. >> INSPECTION END IGNITION TIMING Inspection 1.CHECK IGNITION TIMING Attach timing light (A) to th ...

Rear wiper motor
Exploded View Rear wiper motor Back door Rear wiper motor harness Removal and Installation REMOVAL Remove rear wiper arm. Refer to WW-69, "Removal and Installation". Remove back door finisher. Refer to INT-38, "Removal and Installation". & ...