Nissan Rogue manuals

Nissan Rogue Service Manual: The low washer fluid warning continues displaying, or does not display

Nissan Rogue Service Manual / Driver information & multimedia / Meter, Warning Lamp & Indicator / Symptom diagnosis / The low washer fluid warning continues displaying, or does not display

Description

Diagnosis Procedure

1.CHECK WASHER FLUID LEVEL SWITCH SIGNAL CIRCUIT

Check the washer fluid level switch signal circuit. Refer to MWI-71, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace harness or connector.

2.CHECK WASHER FLUID LEVEL SWITCH UNIT

Check the washer fluid level switch. Refer to MWI-71, "Component Inspection".

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-82, "Removal and Installation".

NO >> Replace washer fluid level switch. Refer to WW-58, "Removal and Installation".

The parking brake release warning continues displaying, or does not display
Description The parking brake warning is displayed during vehicle travel even though the parking brake is released.  The parking brake warning is not displayed even though driving the ...

The door open warning continues displaying, or does not display
Description The door open warning is displayed even though all of the doors are closed.  The door open warning is not displayed even though a door is ajar. Diagnosis Procedure 1.CHEC ...

Other materials:

P0011 IVT control
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P0011 INT/V TIM CONT-B1 (″A″ Camshaft position - timing over-advanced or system performance bank 1) There is a gap between angle of ...

Symptom diagnosis
INTELLIGENT KEY SYSTEM SYMPTOMS Symptom Table CAUTION: Perform the self-diagnosis with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected. Symptom Inspection item Door does not lock/unlock with door lock and unlock switch ...

Filament
Inspection and Repair INSPECTION  When measuring voltage, wrap tin foil around the top of the negative probe. Then press the foil against the wire with your finger. Attach probe circuit tester (in Volt range) to middle portion of each filament. If a filament is b ...

В© 2014-2023 Copyright www.nirogue.com