Nissan Rogue (T33) 2021-Present Service Manual: Rdr-Rl Branch Line Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Lan System / Can :: Dtc/circuit Diagnosis / Rdr-Rl Branch Line Circuit

Diagnosis Procedure

CHECK CONNECTOR

  1. Turn the ignition switch OFF.

  2. Disconnect the battery cable from the negative terminal.

  3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).

    • Side radar rear LH

    • Harness connector B456

    • Harness connector B79

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair the terminal and connector.

CHECK HARNESS FOR OPEN CIRCUIT

  1. Disconnect the connector of side radar rear LH.

  2. Check the resistance between the side radar rear LH harness connector terminals.

    • Without ProPILOT Assist 2.1

      Side radar rear LH harness connector Resistance (Ω)
      Connector No. Terminal No.
      B461 1 2 Approx. 108 – 132
      8 7 Approx. 108 – 132

    • With ProPILOT Assist 2.1

      Side radar rear LH harness connector Resistance (Ω)
      Connector No. Terminal No.
      B467 1 2 Approx. 108 – 132
      8 7 Approx. 108 – 132

Is the measurement value within the specification?

YES>>

GO TO 3.

NO>>

Repair the side radar rear LH branch line.

CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the side radar rear LH. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES (Present error)>>

Replace the side radar rear LH. Refer to Removal and Installation.

YES (Past error)>>

Error was detected in the side radar rear LH branch line.

NO>>

Repair the power supply and the ground circuit.

    Laser Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damag...
    Avm Branch Line Circuit (its Can Communication 3 Circuit)
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the around view ...

    Other materials:

    U1cab-02 Intake Door Motor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1CAB-02 Intake door motor (Intake door motor) Diagnosis condition Ignition switch ON Signal (Terminal) LIN (door motor) signal Threshold A/C amp. i ...

    Corrosion protection
    Most common factors contributing to vehicle corrosion Moisture-retaining dirt and debris build-up inside body cavities or seams. Paint or coating damage caused by gravel, small stones or minor collisions. Environmental factors influencing corrosion rate Moisture Sand, dirt and water accumulat ...

    Dtc/circuit Diagnosis. U2141-87 Can Comm Circuit
    DTC Description DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern Nissan Ariya vehicle is equipped ...