Nissan Rogue Service Manual: Precaution

Nissan Rogue Service Manual / Maintenance / Precaution

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"

The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system safely is included in the SR and SB section of this Service Manual.

WARNING:

To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance must be performed by an authorized NISSAN/INFINITI dealer.
Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag Module, see the SR section.
Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors.

PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS

WARNING:

When working near the Airbag Diagnosis Sensor Unit or other Airbag System sensors with the Ignition ON or engine running, DO NOT use air or electric power tools or strike near the sensor(s) with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing serious injury.
When using air or electric power tools or hammers, always switch the Ignition OFF, disconnect the battery and wait at least three minutes before performing any service.

Maintenance

...

Preparation

Special Service Tool The actual shapes of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description KV991J0070 (J-45695-A ...

Other materials:

B2268 water temp
Description The engine coolant temperature signal is transmitted from ECM to the combination meter via CAN communication. DTC Logic DTC DETECTION LOGIC DTC CONSULT Detection Condition Possible Cause B2268 WATER TEMP [B2268] ECM continuously tra ...

Rear disc brake
BRAKE PAD BRAKE PAD : Inspection INSPECTION Check brake pad wear thickness from an inspection hole (A) on cylinder body. Check using a scale if necessary. Wear thickness : Refer to BR-55, "Rear Disc Brake". DISC BRAKE ROTOR DISC BRAKE ROTOR : Inspection Appearance Check surfac ...

U1000 CAN COMM circuit
Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each co ...