Nissan Rogue Service Manual: B2268 water temp
Description
The engine coolant temperature signal is transmitted from ECM to the combination meter via CAN communication.
DTC Logic
DTC DETECTION LOGIC
|
DTC |
CONSULT |
Detection Condition |
Possible Cause |
| B2268 | WATER TEMP [B2268] | ECM continuously transmits abnormal engine coolant temperature signals for 60 seconds or more. |
|
Diagnosis Procedure
1.PERFORM SELF DIAGNOSIS OF ECM
Perform "Self Diagnostic Result" of "ECM", and repair or replace malfunctioning parts.
>> Refer to EC-93, "DTC Index".
B2267 engine speed
Description
The engine speed signal is transmitted from ECM to the combination meter with
CAN communication.
DTC Logic
DTC DETECTION LOGIC
DTC
CONSULT
Detection Conditio ...
Power supply and ground circuit
COMBINATION METER
COMBINATION METER : Diagnosis Procedure
Regarding Wiring Diagram information, refer to MWI-32, "Wiring Diagram".
1.CHECK FUSES
Check that the following fuses are not bl ...
Other materials:
Air bag diagnosis sensor unit
Exploded View
Diagnosis sensor unit
Front
Removal and Installation
WARNING:
Before servicing the SRS, turn ignition switch OFF, disconnect
both battery terminals then wait at
least three minutes.
Before disconnecting the air bag diagnosis sensor unit harness
...
AM radio reception
AM signals, because of their low frequency, can
bend around objects and skip along the ground.
In addition, the signals can be bounced off the
ionosphere and bent back to earth. Because of
these characteristics, AM signals are also subject
to interference as they travel from transmitter
to r ...
DTC/circuit diagnosis
P1610 LOCK MODE
Description
ECM forcibly switches to the mode that inhibits engine start, when engine
start operation is performed 5 times
or more while communication between ECM and BCM is not normal.
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC B1610 is displayed with DTC U1000, fi ...
