Nissan Rogue Service Manual: Precaution

Nissan Rogue Service Manual / Body exterior, doors, roof & vehicle security / Security Control System / Without intelligent key system / Precaution

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"

The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system safely is included in the SR and SB section of this Service Manual.

WARNING:

To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance must be performed by an authorized NISSAN/INFINITI dealer.
Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag Module, see the SR section.
Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors.

PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS

• When working near the Airbag Diagnosis Sensor Unit or other Airbag System sensors with the Ignition ON or engine running, DO NOT use air or electric power tools or strike near the sensor(s) with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing serious injury.
When using air or electric power tools or hammers, always switch the Ignition OFF, disconnect the battery and wait at least three minutes before performing any service.

Without intelligent key system

...

System description

COMPONENT PARTS Component Parts Location No. Component Function 1 Combination meter Combination meter transmits the vehicle speed signal to BCM via CAN ...

Other materials:

Fender protector
FENDER PROTECTOR FENDER PROTECTOR : Exploded View Front fender protector Engine side cover Front fender Over fender Clip Front FENDER PROTECTOR : Removal and Installation REMOVAL Remove wheel and tire using power tool. Refer to WT-60, "Removal and Install ...

Preparation
Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description — (J-39570) Chassis Ear Locating the noise — (J-50397) NISSAN Squeak and Rattle Kit ...

Plug
Description Replace the O-ring if oil leakage or exudes from the plug. Exploded View Transaxle assembly O-ring Plug : Always replace after every disassembly. : N·m (kg-m, ft-lb) : Apply CVT fluid Removal and Installation REMOVAL Partially remove front fender prote ...