Nissan Rogue Service Manual: Precaution

Nissan Rogue Service Manual / Body exterior, doors, roof & vehicle security / Security Control System / With intelligent key system / Precaution

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"

The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system safely is included in the SR and SB section of this Service Manual.

WARNING:

To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance must be performed by an authorized NISSAN/INFINITI dealer.
Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag Module, see the SR section.
Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors.

PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS

WARNING:

When working near the Airbag Diagnosis Sensor Unit or other Airbag System sensors with the Ignition ON or engine running, DO NOT use air or electric power tools or strike near the sensor(s) with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing serious injury.
When using air or electric power tools or hammers, always switch the Ignition OFF, disconnect the battery and wait at least three minutes before performing any service.

With intelligent key system

...

System description

COMPONENT PARTS Component Parts Location View right of steering column. No. Component Function 1 Combination meter Combination meter transmits the v ...

Other materials:

Wiring diagram
NAVIGATION WITH BOSE Wiring Diagram ...

Power supply and ground circuit
Diagnosis Procedure 1.CHECK FUSE Check that the following fuse is not fusing. Is the fuse fusing? YES >> Replace the fuse after repairing the applicable circuit. NO >> GO TO 2. 2.CHECK GROUND CONNECTION Turn ignition switch OFF. Check ground connection E9 or E ...

BSW system operation
BSW system operation The BSW system operates above approximately 20 MPH (32 km/h). When the camera unit detects vehicles in the detection zone, the Blind Spot indicator light located inside the outside mirrors will illuminate. If the turn signal is then activated, the system chimes (twi ...