Nissan Rogue (T33) 2021-Present Service Manual: P155e Generator Voltage

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P155e Generator Voltage

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P155E 00

GENERATOR VOLTAGE

(GENERATOR VOLTAGE) 		Diagnosis condition Ignition switch ON
Signal (terminal) Power supply
Threshold Battery voltage measured by ECM below threshold.
Diagnosis delay time 20 seconds or more

POSSIBLE CAUSE

  • Harness and connectors

  • ECM

  • IPDM E/R

  • Battery

  • Generator

FAIL-SAFE

Engine Control System

Not applicable

Stop/Start System

When a DTC is detected, the stop/start indicator lamp blinks slowly and the stop/start system operation is prohibited.

When ECM detects error while operating the stop/start system, ECM restarts the engine.

CONFIRMATION PROCEDURE

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.

>>

GO TO 2.

DTC CONFIRMATION PROCEDURE

  1. Start engine and let it idle for at least 20 seconds.

  2. Check DTC.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK CHARGE SYSTEM

Check charge system. Refer to Work Flow (With EXP-800 NI or GR8-1200 NI)or Work Flow (Without EXP-800 NI or GR8-1200 NI).

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Repair or replace the error-detected parts.

    P155b Energy Management Control
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P155B 00 Electrical energy management system (Electrical energy ...
    P155f Generator Voltage
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P155F 00 GENERATOR VOLTAGE (GENERATOR VOLTAGE) Diagnosis conditi...

    Other materials:

    Removal and Installation. Steering Gear and Linkage
    Exploded View 1. Outer socket 2. Boot clamp (small diameter) 3. Boot 4. Boot clamp (large diameter) 5. Hole cover seal A. Outer socket lock nut. B. Inner socket lock nut. — — — — CAUTION: Never apply the grease to the surface be ...

    Electric Shift Control Module
    Exploded View Electric shift control module         : N·m (kg-m, in-lb) : Vehicle front Removal and Installation REMOVALDisconnect the negative battery terminal. Refer to Exploded View. Remove instrument side panel LH. Refer to Exploded View. Disconnect the harn ...

    Repair Information. Service Data and Specifications (sds)
    Body Alignment Body Center Marks Factory marks exist on certain parts of the body to indicate the vehicle center. When repairing the Nissan Ariya vehicle frame (members, pillars, etc.) damaged in an accident, the most accurate and effective repair will be achieved by using these marks togeth ...