Nissan Rogue (T33) 2021-Present Service Manual: P02f0 Fuel Injector

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
P02F0 00

Cylinder 3 injector

(Cylinder 3 Injector Circuit Range/Performance)
Diagnosis condition Injector compensation control is operating
Signal
Threshold When the injector compensation value is above or below the threshold value.
Diagnosis delay time

POSSIBLE CAUSE

  • ECM

  • Fuel injector

  • Harness or connectors (Fuel injector circuit is open or shorted.)

FAIL-SAFE

Engine Control System

Not applicable

Stop/Start System

When a DTC is detected, the stop/start indicator lamp blinks slowly and the stop/start system operation is prohibited. When ECM detects error while operating the stop/start system, ECM restarts the engine.

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE-1

  1. Start the engine.

  2. Let engine idle for 20 seconds.

  3. Check the DTC.

Is the DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK FUEL INJECTOR

Check fuel injector. Refer to Component Function Check.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace error-detected parts.

REPLACE ECM

  1. Replace ECM. Refer to ECM : Removal & Installation.

  2. Perform DTC confirmation procedure again. Refer to DTC Description.

  3. Check the DTC.

Is the DTC P02F0 displayed again?

YES>>

Check intermittent incident. Refer to Intermittent Incident.

NO>>

INSPECTION END

    P02ef Fuel Injector
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P02EF 00 Cylinder 2 injector (Cylinder 2 Injector Circuit Range/...
    P0300 Misfire
    DTC Description DTC DETECTION LOGICWhen a misfire occurs, engine speed will fluctuate. If the engine speed fluctuates enough to cause the crankshaft position (CKP) sensor signal...

    Other materials:

    P1c90-49 Sub Starter & Generator
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition P1C90-49 Sub starter & generator (Sub starter & generator) Diagnosis condition Engine running at idle Signal (terminal) - Threshold Sub starte ...

    Chassis control
    Basic information The chassis control system in the Nissan Rogue uses an electric control module that manages the following functions: Intelligent Trace Control Active Ride Control (if so equipped) Intelligent Trace Control This feature analyzes the driver’s steering, acceleration and braking ...

    C0513 Wheel Speed Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition C0513 00 Right rear wheel speed sensor (Right Rear Wheel Speed Sensor Range/Performance) Diagnosis condition Ignition switch ON Battery voltage: 11 V ...